Yamaha MG24/14 FX Owner's Manual | Page 5

Yamaha Musical Instruments Owner's Manual - MG24/14 FX.
Download
Page  of 29
4.8, 1628 votes
background image

 

MG32/14FX, MG24/14FX

 

4

 

Always turn the power off when the device is not in use. 

The performance of components with moving contacts, such as switches, volume controls, and connectors, deteriorates over time. Consult quali-
fied Yamaha service personnel about replacing defective components.

Copying of commercially available music data and/or digital audio files, except for personal use, is strictly prohibited.

Illustrations in this manual are for explanatory purposes only, and may not match the actual appearance of the product during operation.

Company names and product names used in this Owner’s Manual are trademarks or registered trademarks of their respective owners.

 

* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.

(class B)

• This applies only to products distributed by Yamaha-Kemble Music (U.K.) Ltd. (3 wires).

 

XLR-type connectors are wired as follows (IEC60268 standard): pin 1: ground, pin 2: hot (+), and pin 3: cold (–).
Insert TRS phone jacks are wired as follows: sleeve: ground, tip: send, and ring: return.

Yamaha cannot be held responsible for damage caused by improper use or modifications to the device, or data that is lost or destroyed. 

 

IMPORTANT NOTICE FOR THE UNITED KINGDOM

 

Connecting the Plug and Cord

 

WARNING: 

 

THIS APPARATUS MUST BE EARTHED

IMPORTANT. The wires in this mains lead are coloured in accordance with the following code:

GREEN-AND-YELLOW

: EARTH

BLUE : NEUTRAL
BROWN

: LIVE

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured makings identifying the terminals in your
plug proceed as follows:
The wire which is coloured GREEN-and-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety
earth symbol 

 or coloured GREEN or GREEN-and-YELLOW.

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

1.  IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions con-
tained in this manual, meets FCC requirements. Modifications 
not expressly approved by Yamaha may void your authority, 
granted by the FCC, to use the product.

2. IMPORTANT: When connecting this product to accessories 

and/or another product use only high quality shielded cables. 
Cable/s supplied with this product MUST be used. Follow all 
installation instructions. Failure to follow instructions could void 
your FCC authorization to use this product in the USA.

3. NOTE: This product has been tested and found to comply with 

the requirements listed in FCC Regulations, Part 15 for Class “B” 
digital devices. Compliance with these requirements provides a 
reasonable level of assurance that your use of this product in a 
residential environment will not result in harmful interference with 
other electronic devices. This equipment generates/uses radio 
frequencies and, if not installed and used according to the 
instructions found in the users manual, may cause interference 
harmful to the operation of other electronic devices. Compliance 

with FCC regulations does not guarantee that interference will 
not occur in all installations. If this product is found to be the 
source of interference, which can be determined by turning the 
unit “OFF” and “ON”, please try to eliminate the problem by using 
one of the following measures:
Relocate either this product or the device that is being affected by 
the interference. 
Utilize power outlets that are on different branch (circuit breaker 
or fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the 
antenna. If the antenna lead-in is 300 ohm ribbon lead, change 
the lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results, 
please contact the local retailer authorized to distribute this type 
of product. If you can not locate the appropriate retailer, please 
contact Yamaha Corporation of America, Electronic Service Divi-
sion, 6600 Orangethorpe Ave, Buena Park, CA90620
The above statements apply ONLY to those products distributed 
by Yamaha Corporation of America or its subsidiaries.

FCC INFORMATION (U.S.A.)

 

MG32-14FX_E.book  Page 4  Thursday, June 12, 2003  3:10 PM

0.492662s