Whirlpool Whirlpool Dishwasher ADP6000IX User's Manual | Page 6

Whirlpool Dishwasher User's Manual - Whirlpool Dishwasher ADP6000IX.
Download
Page  of 13
4.8, 1627 votes
background image

4

Dishwasher detergent is corrosive! Take care to keep it out 

of reach of children.

To remove hard water spots, try the following:

     Run dishes through a normal wash program.

     Remove all metal dishware, such as cutlery, pans, etc., 

from

 

the

 

dishwasher.

      Do not add detergent.

     Pour two cups of vinegar into a bowl and set the bowl face 

up

 

on

 

the lower

 

rack

 

of

 

the

 

dishwasher.

      Run the dishes through a normal wash program.

If this doesn't work, try the same process with 1 / 4 cup of 

citric acid crystals instead of vinegar.

Use only detergent specifically made for use in dishwashers. 
Keep your detergent fresh and dry. Don't put powder detergent 
into the dispenser until You're ready to wash dishes.

The dispenser must be refilled before the start of each wash cycle following the instructions provided in the" Wash Cycle 

Table".Your dishwashers 

 than conventional dishwashers. Generally, only one tablespoon of 

detergent is needed for a normal wash load. Also, more heavily soiled items need more detergent. Always add the detergent just 

before starting dishwasher, otherwise it could get damp and will not dissolve properly.

use less detergent and rinse aid

To open the dispenser, turn the cap to the "open" (left) 

arrow and lift it out.

Pour the rinse aid into the dispenser, being careful not to 

overfill.

Replace the cap by inserting it aligned with "open" arrow 

and turning it to the closed (right) arrow.

A measured amount of rinse aid is released during the final rinse. As with detergent, the amount

of rinse aid needed for your dishes depends on the hardness of the water in your area. Too much

rinse aid can result in lather of foaming and cause cloudiness or steaks on your dishes. If the

water in your area is very soft, you may not need rinse aid. If you do,you can dilute the rinse aid

with an equal amount of water.

The rinse aid dispenser has four settings. Always start with the dispenser set on " 1 ". If spots and

poor drying are problems, increase the amount of rinse aid dispensed by removing the dispenser

lid and rotating the dial to "2". If the dishes still are not drying properly or are spotted, adjust the

dial to the next higher number until your dishes are spot-free. We suggest you to set on "3" . 

The rinse aid is released during the final rinse to prevent water 

from forming droplets on your dishes that can leave spots and 
streaks. It also improves drying by allowing water to "sheet" off 

the dishes.

Your dishwashers are designed to use liquid rinse aids. The 

rinse aid dispenser is located inside the door next to the 

detergent dispenser. To fill  the dispenser, open the cap and 

pour the rinse aid into the dispenser until the  level indicator 

turns completely black. The volume of the rinse aid container is

about 140ml.

Be careful not to overfill the dispenser, because this could 

cause oversudsing. Wipe away any spills with a damp cloth. 

Don't forget to replace the cap before you close the dishwasher 

door.

If you have soft water, you may not need rinse aid for it may 

cause a white film to develop on your dishes.  

Main wash

detergent

Pre-wash

detergent

15 25

15 25

THE NORMAL DOSAGE PLEASE REFERENCE TO THE SECTION ENTITLED "WASH CYCLE TABLE"

0.522988s