Whirlpool Side by Side Refrigerator KTRS22EMBL00 User's Manual | Page 9

Whirlpool Refrigerators User's Manual - Side by Side Refrigerator KTRS22EMBL00.
Download
Page  of 56
4.3, 1154 votes
background image

9

4. Determine the length of copper tubing you need. Measure

from the connection on the lower left rear of refrigerator to the
water pipe. Add 7 ft. (2.1 m) to allow for cleaning. Use

¹⁄₄ in.

(6.35 mm) O.D. (outside diameter) copper tubing. Be sure
both ends of copper tubing are cut square.

5. Using a grounded drill, drill a

¹⁄₄ in. hole in the cold water pipe

you have selected.

6. Fasten the shutoff valve to the cold water pipe with the pipe

clamp. Be sure the outlet end is solidly in the

¹⁄₄ in. drilled hole

in the water pipe and that the washer is under the pipe clamp.
Tighten the packing nut. Tighten the pipe clamp screws
carefully and evenly so washer makes a watertight seal. Do
not overtighten or you may crush the copper tubing.

7. Slip the compression sleeve and compression nut on the

copper tubing as shown. Insert the end of the tubing into the
outlet end squarely as far as it will go. Screw compression nut
onto outlet end with adjustable wrench. Do not overtighten.

8. Place the free end of the tubing in a container or sink, and

turn ON the main water supply. Flush the tubing until water is
clear. Turn OFF the shutoff valve on the water pipe. Coil the
copper tubing.

Connecting to Refrigerator

1. Attach the copper tube to the valve inlet using a compression

nut and sleeve as shown. Tighten the compression nut. Do
not overtighten. Use the tube clamp on the back of the
refrigerator to secure the tubing to the refrigerator as shown.
This will help prevent damage to the tubing when the
refrigerator is pushed back against the wall.

2. Turn shutoff valve ON.

3. Check for leaks. Tighten any connections (including

connections at the valve) or nuts that leak.

4. The ice maker is equipped with a built-in water strainer. If

your water conditions require a second water strainer, install it
in the

¹⁄₄ in. (6.35 mm) water line at either tube connection.

Obtain a water strainer from your nearest appliance dealer.

5. Plug in refrigerator or reconnect power.

Water System Preparation

Please read before using the water system.

Immediately after installation, follow the steps below to make
sure that the water system is properly cleaned.

1. Open the freezer door and turn off the ice maker. For Style 1

lift up the wire shutoff arm as shown. For Style 2 move the
switch to the OFF (right) setting as shown. The ON/OFF
switch is located on the top right side of the freezer
compartment.

Style 1

Style 2

NOTES:

If your model has a base grille filter system, make sure the
base grille filter is properly installed and the cap is in the
horizontal position.

Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system.

2. Use a sturdy container to depress the water dispenser bar

until the water begins to flow. Flush the water system by
dispensing and discarding 2 to 3 gal. (8 to 12 L) of water.
Cleaning the system will take approximately 6 to 7 minutes
and will help clear air from the line. Additional flushing may be
required in some households.

NOTE: As air is cleared from the system, water may spurt out
of the dispenser.

3. Open the freezer door and turn on the ice maker. For Style 1

lower the wire shutoff arm. For Style 2 move the switch to the
ON (left) position. Please refer to the “Ice Maker and Storage
Bin/Bucket” section for further instructions on the operation
of your ice maker.

Allow 24 hours to produce the first batch of ice.

Discard the first three batches of ice produced.

Depending on your model, you may want to select the
maximum ice feature to increase the production of ice.

1. Cold Water Pipe
2. Pipe Clamp
3. Copper Tubing
4. Compression Nut

5. Compression Sleeve
6. Shutoff Valve
7. Packing Nut

1. Tube Clamp
2. Copper Tubing

3. Compression Nut
4. Valve Inlet

Related Manuals for Whirlpool Side by Side Refrigerator KTRS22EMBL00

0.524465s