Viper VSS4000 Installation Manual | Page 2

Viper Car Alarm Installation Manual - VSS4000.
Download
Page  of 2
4.2, 1825 votes
background image

2

© 2009 Directed Electronics. All rights reserved.

Addendum: Owner's Guide

 

! ATTENTION OWNER !

The VSS4000 integrates the Viper 5101 Remote Start with the VSM100 Viper SmartStart Module. Read this addendum 

and both installation guides thoroughly before beginning. They will help you understand how to combine the two 

systems, avoid mistakes, and smoothly complete the installation, verification and customer registration processes.

The corrections made in this addendum address the 5101 Owner's guide (G4102V 2008-06) as it pertains to the 

VSN4000 kit.

Owner’s guide 

Page

Description/error 

Correction

9

What's included:

This list has changed to integrate 

two systems, see Correction column.

The VSS4000 system includes:

VSM100 Viper SmartStart module, wire harness, Quick 

reference User's & Installation guide. Module ID stickers.

5101V remote start/keyless entry main module, Owner's 

guide and this addendum

Control Center with integrated Valet Override switch

One five button/1way Supercode remote control

Window decals

Warranty registration cards

10

"Battery replacement" procedure is 

incorrect.

See “Battery Replacement” procedure below. 

11

Item 7 reference to battery door is 

incorrect.

There is no battery door on the 7153V remote control.

13

Unlock section title at top of page is 

incorrect.

Aux/Trunk command instruction 

"Press one time" is incorrect.

Top section title next to closed lock icon should be "Lock".

Should be "Press and Hold for 1 1/2 seconds".

16

Unlocking the Vehicle begins:

Lock the vehicle normally. Press.....

Should read:

To Unlock the vehicle. Press.....

All

References to "beeps" on most 

pages of the guide are incorrect.

Beep generator has been removed from the 7153V remote 

control, references to LED blinks are correct.

Battery Replacement

Using a small slotted screwdriver or similar tool, insert into unit slot and gradually pry the top away from the 

1. 

bottom until free. 

Remove the top along with the circuit board and turn both upside down. Remove battery from battery clip and 

2. 

replace.  

Note: Verify polarity while replacing the battery as the battery clip will also accept the battery if incorrectly 

inserted upside down.

With the unit top and circuit board still upside down. Turn unit bottom over and onto the other two parts. Snap 

3. 

unit back together. 

+

+

+

+

+

+

 

0.482548s