Vax ALL TERRAIN V-125 Instruction Manual | Page 7

Vax Vacuum Cleaners Instruction Manual - ALL TERRAIN V-125.
Download
Page  of 20
4.1, 1170 votes
background image

7

Vax Careline 0870 606 1248

operation

The cleaner will no longer pick up dirty solution and the
motor sound will become noticeably higher in pitch.

When this happens, turn cleaner off and empty recovery
tank before continuing use. Check clean water tank also; it
may need to be refilled.

Do not use without float and float retainer in place. If
broken or dislodged, take to an Authorized Vax Service
Center or Dealer for repair.

Brush Setting Selector

Your cleaner has two brushbar settings:
ON - for normal cleaning of carpets and bare floors.
OFF - for cleaning carpets and bare floors when brushing
is not desired, such as when picking up liquid spills.

Slide setting selector (A) to the desired setting before
cleaning (Fig.4/6).

Wash/Rinse Switch

This switch allows you to easily change from cleaning your
carpet with a solution/water mix to rinsing with water
only.

Set the switch to WASH to clean the carpet of floor with
solution and water. Set the switch to RINSE to use water
only (Fig.4/7).

See section 5 for more details.

Clean Water Tank (Upper Tank)

The clean water tank (A) holds the water  that will either
be mixed with solution for cleaning the carpet or floor, or
used to rinse the carpet.

The solution container (B) is permanently attached to the
water tank. It holds the solution that mixes with the water
(Fig.4/8).

Filling the Clean Water Tank

Unplug cleaner from electrical outlet. Place cleaner handle
in the upright, locked position.

To remove tank, press down on tank handle and pull
forward (Fig.4/9).

ON

OFF

WAS

H

AUT

ORI

NSE

Rin

se

Fig.4/7

Fig.4/9

Fig.4/8

Fig.4/6

Fig.4/5

A

A

A

B

 

Related Manuals for Vax ALL TERRAIN V-125

0.491813s