Toro 52208 Installation Instructions

Wood Accent Light
Download
Page  of 2
4.9, 1640 votes
background image

Two

Pull the burned-out lamp straight
out of the socket, and replace it
with a new lamp.  Use only a
standard 7-watt lamp No. 918
(Toro Model 52960).

Note: If the lamp does not light,
check whether the wires on the
lamp are pinched by the contacts.

INSTALLATION

 GUIDE

FORM NO. 3315-926 

MODEL NO. 52208  39000001 & up  

Wood Accent Light

 ®

One

Remove the lens by
holding it on the
bottom corners and
pulling downward.

Three

Replace the lens by
aligning it with the
backplate and
snapping it into
place.

Application A

To assemble with the top only: fasten the top to the
backplate, and fasten the reflector and backplate to the
rail using 5/8-inch screws.  Run the cable out of the
channel on either side.

Application B

You can also mount the Deck Light flush on a rail or
wall by flipping the top of the other side of the backplate
as shown at the left.  First attach the backplate and
reflector to the top, then mount with 5/8-inch screws,
running cable out the channel on either side.

Application C

The lens and backplate can be offset for backlighting by
using the upper holes on the backplate.  Fasten the
reflector and top to the backplate, then fasten the fixture
to the rail with 5/8-inch screws.

Lamp Replacement Procedure

Installation Procedures

The Toro
Woodlights™ Lights
are made of the
highest-quality heart
redwood.  Before
assembling your
lights, you may want
to seal the wood
parts with a clear
exterior sealer, wood
stain or paint.  Or you
may let the wood
weather naturally to
a grey.  If you use
sealer or paint on
your deck lights, be
sure the parts are
completely dry
before assembling.

0.595893s