Toro 52207 Installation Instructions

Mini Spot Light
Download
Page  of 1
4.2, 1380 votes
background image

1. Remove the top by pulling up on one edge.

2. Pull the burned out lamp straight out of the socket.

Replace the new lamp by pushing a standard 12-watt
No. 912 lamp (Toro model 52977) or the optional 18-
watt No. 921 lamp (Toro Model 52976).

3. Replace the top onto the fixture by pressing it firmly in

place and rotating it until the snaps align.

INSTALLATION GUIDE

FORM NO. 3315–925 

MODEL NO.  52207  39000001 & up  

20-Watt Halogen Varifocus  MiniSpot  Light

 ®

®

6" minimum

One

Place cable over the
contacts in the cable
channel on the back of the
fixture head.  Press down
firmly.

Two

Push the ground stake into
the back of the fixture
head.  Insert the bolt
through the fixture head
and stake.

Three

Screw the knob onto the
bolt to secure it and insert
the cable into the slots in
the side of the ground
stake..

Five

To adjust the light beam
from narrow to broad,
turn the focus ring.  Be
careful not to touch the
lens.  When the fixture is
operating, it becomes
very hot.

Four

Make a hole in the ground about 8" deep.  Do not push the
stake into the ground without making a hole first or you
may damage the stake.  Insert the stake into the hold and
push dirt around the stake.  Do not hammer or press hard
on the lamp-head assembly.

Lamp Replacement Procedure

Installation Procedure

The most important

part of installing the

fixtures is making sure

their metal pins

pierce the wire inside

the cable: 

You’ll know they’re

well-aligned and the

wire was pierced

when the light 

comes on.

Misaligned

Piercing

Points

Correct

Piercing

Points

This

Not This

0.631826s