Toro 22193 Addendum

PT21 Trim Mower (serial 280000001 - 280999999)
Download
Page  of 2
4.9, 1520 votes
background image

Form No. 3360-643 Rev A

Commercial Trim Mowers

Various Models

Addendum

Important: The instructions in this Addendum replace procedure 1 in Setup in your Operator’s Manual;
therefore, use these instructions when you set up your mower.

Note: In your Parts Catalog, replace the 2 hex-head screws (322-7) in the handle assembly with the 2 handle screws
(92-4095). Also, replace the 2 self-tapping hex head screws (701243) with the 2 self-tapping hex head screws
(32144-49). The spacer (5-0652) is not listed in your Parts Catalog. Therefore, keep this Addendum with your Parts
Catalog
.

1

Installing the Handle

Parts needed for this procedure:

6

Oval-head bolt (models 22164, 22164TE, and 22194
only)

6

Locknut (models 22164, 22164TE, and 22194 only)

1

Upper handle (models 22164, 22164TE, and 22194
only)

2

Oval-head bolt (models 22163 and 22193 only)

2

Locknut (models 22163 and 22193 only)

2

Self-tapping hex head screw (32144-49; all models)

2

Washer (all models)

2

Spacer (5-0652; all models)

1

Cable tie (all models)

Procedure

1. Attach the upper handle to the lower handle using

4 oval-head bolts and 4 locknuts (Models 22164,
22164TE, and 22194 only).

Note: Ensure that the bolt heads are to the outside
of the handle.

2. Attach the handle to the mower housing with

2 self-tapping hex head screws, 2 washers, and
2 spacers (Figure 1), but do not tighten the
self-tapping hex head screws.

Note: Ensure that you insert the spacers between
the mower housing and the handle (Figure 2).

Figure 1

1.

End cap on rear door rod

4.

Handle brace (2)

2.

Self-tapping hex head
screw, washer, and spacer
(2)

5.

Bolt head aligned with the
handle

3.

Locknut (2)

© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420

Register at www.Toro.com.

Original Instructions (EN)

Printed in the USA.

All Rights Reserved

0.588055s