Toro 130-4457 Operator's Manual
Form No. 3407-669 Rev A
Standard-Range Exit-Side Lockout Kit
2024 Directional Drill
Model No. 130-4457
Operator's Manual
Note: This kit (130-4457) contains the handheld
transmitter (130-4458) and the receiver (130-4459). If you
are receiving this kit with your drill, the receiver is factory
installed on the drill.
Introduction
The exit-side lockout transmitter and receiver is
designed to remotely stop and lockout the user controls
of a directional drill.
Read this information carefully to learn how to operate and
maintain your machine properly and to avoid injury and
equipment damage. You are responsible for operating the
machine properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol (Figure 1),
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
Figure 1
1.
Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
This product complies with all relevant European directives.
For details, see the separate product-specific Declaration of
Conformity (DOC) sheet.
This product may contain material that may be hazardous to
human health and the environment. In compliance with EU
Directive 2002/96/EC on Waste Electrical and Electronic
Equipment (WEEE):
•
Do not dispose of the product as unsorted municipal
waste.
•
This product should be recycled in accordance with
local regulations. Contact local authorities for detailed
information.
•
This product may be returnable to the distributor for
recycling. Contact your distributor/dealer for details.
FCC Statements
15.19 – Two Part Warning
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
15.21 – Unauthorized Modification
NOTICE: The manufacturer is not responsible for any
unauthorized modifications to this equipment made by the user.
Such modifications could void the user’s authority to operate
the equipment.
15.105(b) – Note:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Industry Canada Statement
This device complies with Canadian RSS-210.
The installer of this radio equipment must ensure that the
antenna is located or pointed such that it does not emit RF field
in excess of Health Canada limits for the general population;
consult Safety Code 6, obtainable from Health Canada’s
website www.hc-sc.gc-ca/rpb.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3407-669* A
Also See for Toro 130-4457
Related Manuals for Toro 130-4457
-
Simplicity Utility Vehicle LEAF SHREDDER KIT 1686609 User's Manual
1 pages
-
Toro Utility Vehicle Workman HDX-D-4WD (07387) Brochure
8 pages
-
Toro Utility Vehicle Workman MDX (07273) Accessory Guide
4 pages
-
Toro Utility Vehicle Workman HDX (07367) Accessory Guide
5 pages
-
Toro Utility Vehicle Workman HDX-D-4WD (07371) Sell Sheet
5 pages
-
Snapper Utility Vehicle SNAPPER GROUNDS CRUISER UTILITY VEHICLE User's Manual
6 pages
-
Snapper Utility Vehicle GC9520KW User's Manual
40 pages
-
Genie Utility Vehicle GL-8 User's Manual
26 pages
-
Genie Utility Vehicle GTH-4010 User's Manual
2 pages
-
Genie Utility Vehicle DPL-35S User's Manual
31 pages
-
Genie Utility Vehicle GS-2032 User's Manual
34 pages
-
Genie Utility Vehicle GS-2632 User's Manual
34 pages
-
Chicago Electric Utility Vehicle 90282 User's Manual
9 pages
-
John Deere Utility Vehicle GATOR CX User's Manual
2 pages
-
John Deere Utility Vehicle Gator TS User's Manual
2 pages
-
John Deere Utility Vehicle Gator XUV 620i User's Manual
2 pages
-
John Deere Utility Vehicle Gator XUV 850D User's Manual
2 pages
-
John Deere Utility Vehicle Gator TX User's Manual
2 pages
-
Bird Brain Utility Vehicle Bird 4391A User's Manual
47 pages
-
Frontier Labs Utility Vehicle RB2060 User's Manual
6 pages
-
Frontier Labs Utility Vehicle RB2060L User's Manual
6 pages
-
Frontier Labs Utility Vehicle RB2072 User's Manual
6 pages
-
Kubota Utility Vehicle RTV-X900 Operator's Manual
114 pages
-
Kawasaki Utility Vehicle MULE 610 4×4 Service Manual
371 pages