Toro 106-0798 Installation Instructions

Center Spindle Shaft Replacement Kit, 36in/52in Mid-Size Mowers
Download
Page  of 2
4.2, 1162 votes
background image

All Rights Reserved

Printed in the USA

1

 2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN  55420-1196

Spindle Shaft Replacement Kit
36 inch, 44 inch, and 52 inch Mid–Size Mowers
Part No. 106–0796
Part No. 106–0797
Part No. 106–0798
Part No. 106–0799

Form No. 3329–352

Installation Instructions

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use the chart below to verify all parts have been shipped.

Description

Qty.

Use

Spindle shaft

Bearing

Bearing spacer

Bearing shield

1

2

1

1

Installing the spindle shaft and bearings

Removing the Existing Spindle
Shaft

Note: Clean the mower thoroughly. Make sure both the top
and bottom the the mower is cleaned.

1. Remove the PTO belt and the mower belt from the

mower. Refer to the mower Operator’s Manual for
removing the PTO and mower belt.

2. Remove the mower blade.

3. Remove the nut and washer on top of the pulley

(Fig. 1).

4. Remove the pulley assembly (Fig. 1).

5. Remove the existing spindle shaft.

6. Remove the upper and lower bearing from the spindle

housing.

Note: The bearings may need to be tapped out with a
punch. Do not damage the spindle housing.

7. Remove the bearing spacer.

8. Check the inside of the spindle housing  for any dirt,

grease or debris and remove it.

0.615896s