Sunbeam 001950-000-302 Owner's Manual

Sunbeam Appliances Owner's Manual - 001950-000-302 .
Download
Page  of 2
4.1, 2054 votes
background image

HOW TO USE YOUR WARMING PAD

1.  Lay the fabric cover on a flat surface with the 

printing face down. Open the snap(s).

2.  Insert the pad into the cover completely. Make sure the 

cord and switch remain on the outside of the cover.

3.  The pad will lie flat, filling the entire cover. Close snap(s).

4.  Plug into any 110-120 volt AC electrical outlet and 

turn the switch to the “on” position.

5.  Wait for the pad to heat up.
WARNING: Never use the warming pad without the fabric cover.

FABRIC COVER WASHING 

INSTRUCTIONS

DO NOT DRY CLEAN! DO NOT BLEACH! 

DO NOT USE WRINGER!

1.  Disconnect pad from outlet.

2.  Remove cover from pad. (Figure 1)

3.  Machine or hand wash; use mild 

detergent. Wash with cool water only.

4.  Hang to dry or machine dry on 

gentle, cool cycle. (Figure 2)

TROUBLESHOOTING

PROBLEM

SOLUTIONS

No Heat

Unplug unit from wall outlet.
Verify no physical damage to the cord, switch or pad.
Verify AC outlet is functional.
Restart unit by turning the controller switch to “off” 

position, and then back to “on”.
Make sure pad is not folded or bunched in any area 

Pad doesn’t get  

hot enough

Make sure pad is not folded or bunched in any area

www.sunbeam.com

Figure 1

Figure 2

A. Machine-WashableCoverwith

Hand-WarmingPocket

B. On/OffSwitchIndicator

A

B

1-Year Limited WarrantY

Sunbeam  Products,  Inc.  doing  business  as  Jarden  Consumer  Solutions  or  if  in  Canada,  Sunbeam  Corporation 

(Canada) Limited doing business as Jarden Consumer Solutions (collectively “JCS”) warrants that for a period of 

one year from the date of purchase, this product will be free from defects in material and workmanship. JCS, at its 

option, will repair or replace this product or any component of the product found to be defective during the warranty 

period. Replacement will be made with a new or remanufactured  product or component. If the product is no 

longer available, replacement may be made with a similar product of equal or greater value. This is your exclusive 

warranty. Do NOT attempt to repair or adjust any electrical or mechanical functions on this product. Doing so will 

void this warranty. This warranty is valid for the original retail purchaser from the date of initial retail purchase and 

is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. 

JCS dealers, service centers, or retail stores selling JCS products do not have the right to alter, modify or any way 

change the terms and conditions of this warranty. This warranty does not cover normal wear of parts or damage 

resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use 

contrary to the operating instructions, disassembly, repair or alteration by anyone other than JCS or an authorized 

JCS service center. Further, the warranty does not cover: Acts of God, such as fire, flood, hurricanes and tornadoes.
What are the limits on JCS’s Liability?

JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or 

statutory warranty or condition. Except to the extent prohibited by applicable law, any implied warranty or condition 

of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty.

JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise. JCS 

shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use 

the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of 

contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. Some provinces, 

states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations 

on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. This warranty 

gives you specific legal rights, and you may also have other rights that vary from province to province, state to 

state or jurisdiction to jurisdiction.
How to Obtain Warranty Service

In the U.S.A. - If you have any question regarding this warranty or would like to obtain warranty service, please 

call 1-800-435-1250 and a convenient service center address will be provided to you.

In Canada, - If you have any question regarding this warranty or would like to obtain warranty service, please call 

1-800-667-8623 and a convenient service center address will be provided to you.

In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions 

located in Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited 

doing business as Jarden Consumer Solutions, located at 20 B Hereford Street, Brampton, Ontario L6Y 0M1. If you 

have any other problem or claim in connection with this product, please write our Consumer Service Department.

PLEASE DO NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE.

©2011 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Distributed by 

Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431.
Printed in China. 

DW-052611 

PN: 150196

Cozy Spot™ Warming Pad

IMPORTANT SAFETY INSTRUCTIONS

DO NOT DESTROY

DANGER: TO REDUCE RISKS OF BURNS, ELECTRIC 

SHOCK, FIRE, AND PERSONAL INJURY, THIS PRODUCT 

MUST BE USED IN ACCORDANCE WITH THE FOLLOWING 

INSTRUCTIONS:

1.  READ ALL INSTRUCTIONS.

2.  DO NOT USE WHILE SLEEPING.

3.  DO NOT USE ON AN INFANT OR ON AN ANIMAL.

4.  THIS PAD IS NOT TO BE USED ON OR BY AN INVALID, 

A SLEEPING OR UNCONSCIOUS PERSON, A PERSON 

WITH DIABETES, OR A PERSON WITH POOR BLOOD 

CIRCULATION.

5.  DO NOT USE ON AREAS OF INSENSITIVE SKIN.

6.  BURNS CAN OCCUR; CHECK SKIN UNDER PAD FREqUENTLY.

7.  DO NOT USE IN AN OXYGEN ATMOSPHERE.

8.  DO NOT USE PINS OR OTHER METALLIC MEANS TO 

FASTEN THIS PAD IN PLACE.

9.  DO NOT SIT ON OR AGAINST OR CRUSH PAD - AVOID 

SHARP FOLDS.

10.  NEVER PULL THIS PAD BY THE SUPPLY CORD.

11.  DO NOT USE THE CORD AS A HANDLE.

12.  CAREFULLY EXAMINE INNER COVER BEFORE EACH USE. 

DISCARD THE PAD IF INNER COVERING SHOWS ANY 

SIGNS OF DETERIORATION.

13.  NEVER USE PAD WITHOUT THE REMOVABLE COVER IN 

PLACE.

14.  THIS UNIT SHOULD NOT BE USED BY CHILDREN WITHOUT 

ADULT SUPERVISION.

15.  PLACE PAD ON TOP OF AND NOT UNDER THE PART OF 

THE BODY NEEDING HEAT.

16.  USE THIS PAD ONLY ON A 110-120 VOLT AC CIRCUIT. 

UNPLUG WHEN NOT IN USE.

17.  DO NOT TAMPER WITH THIS PAD IN ANY WAY.

18.  THERE ARE NO USER-SERVICEABLE PARTS. IF FOR ANY 

REASON THIS PAD DOES NOT FUNCTION SATISFACTORILY, 

SEE WARRANTY FOR CONSUMER SERVICE INFORMATION.

19.  DO NOT USE THIS PAD WITH LINIMENT, SALVE OR 

OINTMENT PREPARATIONS, ESPECIALLY ONES THAT 

CONTAIN HEAT- PRODUCING INGREDIENTS. SKIN BURNS 

COULD RESULT.

20.  DO NOT BEND OR PINCH CORD AND DO NOT USE IF CORD 

IS DAMAGED.

21.  NEVER LEAVE THE APPLIANCE UNATTENDED, ESPECIALLY 

IF CHILDREN ARE PRESENT.

22.  LOOP CORD LOOSELY WHEN STORING. TIGHT WRAPPING 

MAY DAMAGE CORD AND INTERNAL PARTS.

23.  SAVE THESE INSTRUCTIONS.

THIS APPLIANCE HAS A POLARIzED PLUG (ONE BLADE IS WIDER THAN THE OTHER). TO REDUCE 

THE RISK OF ELECTRIC SHOCK, THIS PLUG IS INTENDED TO FIT IN A POLARIzED OUTLET ONLY 

ONE WAY. IF THE PLUG DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE PLUG. IF IT STILL 

DOES NOT FIT, CONTACT A qUALIFIED ELECTRICIAN TO INSTALL THE PROPER OUTLET.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS 

SAFETY FEATURE IN ANY WAY.

model 1950

Related Manuals for Sunbeam 001950-000-302

0.578291s