Sony BC-VW1 Operating Instructions

Sony Cameras Operating Instructions - BC-VW1.
Download
Page  of 2
4.3, 1842 votes
background image

4-262-124-11(1)

Charging time

Battery pack

NP-FW50

Normal 

charging time

(Approx.)

250 min

For more about the battery life, see the instruction manual of your 

camera.

The charging time may differ depending on the condition of the battery 

pack or the ambient temperature.

The times shown are for charging an empty battery pack, which 

has been run down with a camera, using this unit at an ambient 

temperature of 25 °C (77 °F).

Charging temperature
The temperature range for charging is 0 °C to 40 °C (32 °F to 104 °F).  

For maximum battery efficiency, the recommended temperature 

range when charging is 10 °C to 30 °C (50 °F to 86 °F).

To use the battery pack quickly
You can remove the battery pack from this unit and use it even if 

charging is not completed. However, the charging time affects the time 

that the battery pack can be used.
Notes

If the CHARGE lamp does not light up, check if the battery pack is 

firmly attached to this unit.

When a ful y charged battery pack is installed, the CHARGE lamp 

lights up once and then goes out.

A battery pack that has not been used for a long time may take longer 

than usual to charge.

You can use the battery charger in any country/region where the 

power supply is from 100 V to 240 V AC, 50 Hz/60 Hz.

Do not connect this unit to a voltage adaptor (travel converter) 

for overseas travel. This may result in overheating or another 

malfunction. 

Troubleshooting
When the CHARGE lamp blinks, check through the following chart.

When charging a battery pack that has not been used for a long time, the 

CHARGE lamp may blink in some rare cases.

If this happens, remove the battery pack from this unit and then attach 

and charge it again.
The CHARGE lamp blinks in two ways.

Blinks slowly:  Turns on and off repeatedly every 1.5 seconds

Blinks quickly: Turns on and off repeatedly every 0.15 seconds

The action to be taken depends on the way the CHARGE lamp blinks.
When the CHARGE lamp keeps blinking slowly

Charging is pausing. This unit is in the standby state.

If the room temperature is out of the appropriate temperature range, 

charging stops automatical y.

When the room temperature returns to the appropriate range, the 

CHARGE lamp lights up and charging restarts.

We recommend charging the battery pack at 10 °C to 30 °C (50 °F to  

86 °F).
When the CHARGE lamp keeps blinking quickly

Check through the following chart.

Please contact your nearest Sony dealer in connection with the product that may 

have a problem.

Remove the battery pack that is being charged and then firmly attach the same 

battery pack again.

The CHARGE lamp blinks again:

Install another battery pack.

The CHARGE lamp lights up and 

does not blink again:

If the CHARGE lamp goes out 

because the charging time has 

passed,  there is no problem.

The CHARGE lamp blinks again:

The problem is with this unit.

The CHARGE lamp lights up and 

does not blink again:

If the CHARGE lamp goes out 

because the charging time has 

passed,  the problem is with the 

battery pack first installed.

Specifications
Input rating 

100 V - 240 V AC   50 Hz/60 Hz 

 

8 VA - 13 VA   4.2 W

Output rating 

Battery charge terminal:

 

8.4 V DC  0.28 A

Operating temperature  0 °C to 40 °C (32 °F to 104 °F)

Storage temperature 

–20 °C to +60 °C (–4 °F to +140 °F)

Dimensions 

Approx. 63 mm × 95 mm × 32 mm (w/h/d)

 

(2 1/2 in. × 3 3/4 in. × 1 5/16 in.) 

Mass 

Approx. 85 g (3.0 oz)

Included items 

Battery Charger (BC-VW1) (1)

 

Set of printed documentation

Design and specifications are subject to change without notice.

 is a trademark of Sony Corporation.

Thank you for purchasing the Sony Battery charger.

Before operating this Battery charger, please read this manual thoroughly 

and retain it for future reference.

Owner’s Record

The model and serial numbers are located on the buttom. Record the 

serial number in the space provided below. Refer to these numbers 

whenever you call upon your Sony dealer regarding this product.
Model No. BC-VW1 

Serial No.  

WARNING

To reduce fire or shock hazard, do not expose the unit to rain or moisture.

Do not expose the batteries to excessive heat such as sunshine, fire or the 

like.

IMPORTANT SAFETY 

INSTRUCTIONS

-SAVE THESE INSTRUCTIONS

DANGER

TO REDUCE THE RISK OF FIRE OR 

ELECTRIC SHOCK, CAREFULLY 

FOLLOW THESE INSTRUCTIONS

If the shape of the plug does not fit the power outlet, use an attachment 

plug adaptor of the proper configuration for the power outlet.

This power unit is intended to be correctly orientated in a vertical or 

floor mount position.

The nameplate indicating operating voltage, power consumption, etc. is 

located on the bottom.
Battery to be recharged for this product is follows

Brand Name

Sony

Battery Type

NP-FW50

Rating

DC 7.2 V   

typ.: 7.7 Wh (1,080 mAh)

min.: 7.3 Wh (1,020 mAh)

CAUTION

Connect this unit to an available wall outlet (wall socket). Even when 

the CHARGE lamp of this unit is off, the power is not disconnected. 

If any trouble occurs while this unit is in use, unplug it from the wall 

outlet (wall socket) to disconnect the power.

Do not use this unit in a narrow space such as between a wall and 

furniture.

NOTICE FOR THE CUSTOMERS IN THE U.S.A. 
CAUTION
You are cautioned that any changes or modifications not expressly 

approved in this manual could void your authority to operate this 

equipment.
NOTE
This equipment has been tested and found to comply with the limits for a 

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits  

are designed to provide reasonable protection against harmful 

interference in a residential instal ation. This equipment generates, uses, 

and can radiate radio frequency energy and, if not installed and used 

in accordance with the instructions, may cause harmful interference to 

radio communications.  

However, there is no guarantee that interference will not occur in a 

particular instal ation. If this equipment does cause harmful interference 

to radio or television reception, which can be determined by turning 

the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to 

which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Notes on Use
This unit does not have dust-proof, splash-proof or water-proof 

specifications.

Warranty for Recorded Content

Contents of the recording cannot be compensated if recording or 

playback is not made due to a malfunction of the battery pack, battery 

charger, etc.
Where not to place this unit

Do not place this unit in any of the following locations, whether it is in 

use or in storage. Doing so may lead to a malfunction.

In direct sunlight such as on dashboards or near heating apparatus, as 

this unit may become deformed or malfunction

Where there is excessive vibration

Where there is strong electromagnetism or radiant rays

Where there is excessive sand 

In locations such as the seashore and other sandy areas or where dust 

clouds occur, protect this unit from sand and dust. There is a risk of 

malfunction.

Precautions on Use

Attach the battery pack firmly to this unit when charging the battery 

pack.

To protect the battery pack, remove it from this unit when charging is 

completed.

Do not drop or apply mechanical shock to this unit.

Keep this unit away from TVs or AM receivers. 

Noise from this unit may enter a TV or radio if placed nearby.

Unplug this unit from the wall outlet (wall socket) after use. Hold this 

unit when you unplug it from the wall outlet (wall socket).

Be sure that nothing metallic comes into contact with the metal parts of 

this unit. If it does, a short may occur and this unit may be damaged.

Do not connect this unit to a voltage adaptor (travel converter) for 

overseas travel. This may result in overheating or another malfunction. 

The battery pack and this unit can become warm during or 

immediately after recharging.

Maintenance

If this unit gets dirty, wipe it using a soft dry cloth.

If this unit gets very dirty, wipe it using a cloth with a little neutral 

solvent added, and then wipe it dry.

Do not use thinners, benzine, alcohol, etc., as they will damage the 

surface of this unit.

When you use a chemical cleaning cloth, refer to its instruction 

manual.

Using a volatile solvent such as an insecticide or keeping this unit 

in contact with a rubber or vinyl product for a long time may cause 

deterioration or damage to this unit.

To Charge the Battery Pack
1
  Attach the battery pack.

Keeping the battery mark  in the same direction as the charger mark 

, insert the battery pack until it clicks into place. (See il ustration 

). 

2  Pull the power plug up, and then connect it to a wall outlet 

(wall socket).

Always connect the power plug with the prongs at the top (See 

il ustration ).

Do not connect the power plug with the prongs at the bottom (See 

il ustration ).

The CHARGE lamp (orange) lights up and charging begins.

When the CHARGE lamp goes out, normal charging is completed 

(Normal charge).

For a full charge, which allows you to use the battery pack longer than 

usual, leave the battery pack in place for approximately another one 

hour (Full charge).

To remove the battery pack

Remove the battery pack by sliding it in the opposite direction to when 

you attached it.

The BC-VW1 battery charger can only be used to charge an 

“InfoLITHIUM” battery pack (W series).

“InfoLITHIUM” battery packs (W series) have the 

 mark.

This unit cannot be used to charge a nickel cadmium type or nickel 

metal hydride type battery pack.

“InfoLITHIUM” is a trademark of Sony Corporation.

Battery  mark

Battery pack

Power plug

CHARGE lamp

Charger  mark

© 2010  Sony Corporation   Printed in Japan

BC-VW1

Operating Instructions

Mode d’emploi

Battery Charger
Chargeur de Batterie

0.667405s