Schwinn String-Ray Training Wheels Supplemental Owner's Manual

Schwinn Bikes Owner's Manual - String-Ray Training Wheels Supplemental.
Download
Page  of 2
4.4, 1797 votes
background image

1)  Locate 3 holes in StingRay frame just in front of

rear wheel on lower chain stay. 

2)  Slide Training wheel bracket just below frame between 

chain and frame. Be sure that training wheel bracket 
is facing correctly; the bend should face down when 
the bracket contacts the frame. 

3)   Insert 3 bolts through frame and training wheel

bracket. Install washer and nut for each bolt.
Tighten all bolts securely.

4)   Install training wheels.

 

Order: Training wheel bolt, training wheel, 1st washer, 
training wheel bracket, 2nd washer and fi nally, nut.   

5)   When tightening training wheels note the adjustment 

slot position. Wheels should be even height left and 
right. Adjust so that training wheels are approximately 
1/4" above the ground when bike is held straight.

6)   Check training wheel bracket bolts, and training wheel 

bolts periodically for looseness. Tighten as needed.

StingRay Training Wheel Installation Instructions

STEP 1 and 2

STEPS 3 and 4

STEP 5

0.563632s