Ryobi A113TS1 Owner's Manual

Ryobi Chainsaws Owner's Manual - A113TS1.
Download
Page  of 6
4.9, 2083 votes
background image

OPERATOR’S MANUAL
MANUEL D’UTILISATION 

MANUAL DEL OPERADOR

WARNING: 

To reduce the risk of injury, do not attempt to use this product 

until you have read thoroughly and understand completely this 

operator's manual and the operator's manual for the WS720 

or WS721 Tile Saw.

For use only with the RYOBI WS720 or WS721 tile saw.
SAVE THESE INSTRUCTIONS
UNPACKING

This product requires assembly.
n

  Carefully remove the product from the box. Make sure that all 

items listed in the packing list are included.

WARNING: 

Do not use this product if any parts on the Loose Parts List are 

already assembled to your product when you unpack it. Parts on 

this list are not assembled to the product by the manufacturer 

and require customer installation. Use of a product that may 

have been improperly assembled could result in serious 

personal injury.

n

  Inspect the product carefully to make sure no breakage or 

damage occurred during shipping.

n

  Do not discard the packing material until you have carefully 

inspected and satisfactorily operated the product.

n

  If any parts are damaged or missing, please call 

1-800-525-2579 for assistance.

WARNING: 

If any parts are damaged or missing do not operate this tool 

until the parts are replaced. Use of this product with damaged 

or missing parts could result in serious personal injury.

LOOSE PARTS LIST

See Figure 1.
TOOLS NEEDED

See Figure 2.
Adjustable Wrench or 13 mm Wrench 
ASSEMBLING THE STAND

See Figures 3 - 5.
The support brackets and stand legs have corresponding letters 

for easy assembly.
n

Insert stand legs, labeled “A”, into end tubes of the support 

bracket labeled “A”. Angled ends of stand legs should face away 

from each other so they resemble a “V”. Align holes for hardware. 

Repeat with second support bracket and legs labeled “B”.

n

Fit leg assemblies into braces. Leg assembly “B” rests on inside 

of braces. Leg assembly “A” rests on the outer side. Line up 

holes in the braces and legs. Install hardware through holes.

n

Using wrench, tighten hardware.

n

Place stand on level ground and line up grooves under tile saw 

table with brackets on stand. Position table onto stand.

n

Be sure the tile saw is on level ground and the stand is sturdy 

before use. 

CALIFORNIA PROPOSITION 65

WARNING: 

This product may contain chemicals, including lead, known to 

the State of California to cause cancer, birth defects or other 

reproductive harm. 

Wash hands after handling.

WARRANTY

RYOBI® POWER TOOL - LIMITED THREE YEAR WARRANTY AND 

90 DAY EXCHANGE POLICY
One World Technologies, Inc., warrants its RYOBI® power tools with 

the following conditions:
90-DAY EXCHANGE POLICY: During the first 90 days after date of 

purchase, you may either request service under this warranty or you 

may exchange any RYOBI® power tool which does not work properly 

due to defective workmanship or materials by returning the power tool 

to the dealer from which it was purchased. To receive a replacement 

power tool or requested warranty service, you must present proof of 

purchase and return all original equipment packaged with the original 

product. The replacement power tool will be covered by the limited 

warranty for the balance of the two year period from the date of the 

original purchase.
WHAT THIS WARRANTY COVERS: This warranty covers all defects 

in workmanship or materials in your RYOBI® power tool for a period of 

three years from the date of purchase. With the exception of batteries, 

power tool accessories are warranted for ninety (90) days. Batteries 

are warranted for three years.
HOW TO GET SERVICE: Just return the power tool, properly packaged 

and postage prepaid, to an Authorized Service Center. You can obtain 

the location of the Service Center nearest you by contacting a service 

representative at One World Technologies, Inc., P.O. Box 1207, Anderson, 

SC 29622-1207, by calling 1-800-525-2579 or by logging on to 

www.ryobitools.com. When you request warranty service, you must 

also present proof of purchase documentation, which includes the 

date of purchase (for example, a bill of sale). We will repair any faulty 

workmanship, and either repair or replace any defective part, at our 

option. We will do so without any charge to you. We will complete the 

work in a reasonable time, but, in any case, within ninety (90) days 

or less.
WHAT’S NOT COVERED: This warranty applies only to the original 

purchaser at retail and may not be transferred. This warranty only covers 

defects arising under normal usage and does not cover any malfunction, 

failure or defects resulting from misuse, abuse, neglect, alteration, 

modification or repairs by other than Authorized Service Centers. 

One World Technologies, Inc. makes no warranties, representations 

or promises as to the quality or performance of its power tools other 

than those specifically stated in this warranty.
ADDITIONAL LIMITATIONS: Any implied warranties granted under 

state law, including warranties of merchantability or fitness for a 

particular purpose, are limited to three years from the date of purchase. 

One World Technologies, Inc. is not responsible for direct, indirect, or 

incidental damages, so the above limitations and exclusions may not 

apply to you. This warranty gives you specific legal rights, and you may 

also have other rights which vary from state to state.

TILE SAW STAND
STAND POUR SCIE À CARREAUX 

PEDESTAL PARA SIERRA DE LOSAS
A113TS1

ENGLISH

0.491714s