Radio Shack 61-3005 User's Manual

Radio Shack Switch User's Manual - 61-3005.
Download
Page  of 1
4.3, 1664 votes
background image

Please read this User’s Guide before  

installing, setting up, and using your new product.

www.radioshack.com

Thank you for purchasing the RadioShack Home 

Automation Wall Switch. Your Wall Switch is 

designed to control incandescent lights only, 

with rating between 40W and 500W. It replaces 

your existing switch, and controls both indoor 

and outdoor ceiling lights. A push button is 

provided for local on/off control.

 

Turn the power back on at the circuit 

breaker panel.

 Push the button to turn your wall switch 

on or off.

installing your wall switch

61-3005

home automation 

wall switch

operating your wall switch

©2004. RadioShack Corporation. 
All rights reserved. RadioShack and RadioShack.com are  
trademarks used by RadioShack Corporation.

 

61-3005

06A04

Printed in China

 

Turn the power off at the circuit breaker 

panel.

 

Remove your wall plate and unscrew 

the existing switch from its box.

  Disconnect the wiring from your 

existing switch, and connect the two 

wires on your new switch using the 

wire nuts provided.

  Screw the switch into its wall box.

WARNING: To reduce the risk of fire or shock hazard, do not expose this 
product to rain or moisture.

RISK OF ELECTRIC SHOCK.                                              

 

 

                                              DO NOT OPEN.

 

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE 
COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING 
TO QUALIFIED PERSONNEL.

This symbol is intended to alert you to the presence of  
uninsulated dangerous voltage within the product’s enclosure  
that might be of sufficient magnitude to constitute a risk of  
electric shock. Do not open the product’s case.

This symbol is intended to inform you that important  
operating and maintenance instructions are included in the  
literature accompanying this product.

 

Set the House Code 

dial to the same letter 

that you set on your 

Controller.

 Set the Unit Code  

dial to an unused code.

 

Turn the ON/OFF 

switch beneath the 

push button to ON 

(center position).

  Replace the wall plate 

on your wall box.

setting up your wall switch

Note

Be sure no loose wires are protruding; 
use insulating tape (not provided) to 
cover the wire nuts, if necessary.

Warning

Wall switches must not be used to 
control appliances, low voltage lamps 
or fluorescent lamps!

 

2 screws 

2 wire nuts

 

wall switch 

user’s guide

what’s included

Note

When replacing a light bulb, turn 
your wall switch to OFF 
(left position).

Wire nuts

Screws

Wall Switch

Wires

Push 

 button

ON/OFF

0.551191s