Radio Shack 43-3241 User's Manual

Radio Shack Amplified Phone User's Manual - 43-3241.
Download
Page  of 2
4.4, 2236 votes
background image

© 2002 RadioShack Corporation.

All Rights Reserved.

RadioShack and RadioShack.com are trademarks 

used by RadioShack Corporation.

43-3241

OWNER’S MANUAL — Please read before using this equipment.

(%%"56#6'/'06
Your telephone complies with Part 68 of 
FCC Rules. You must, upon request, 
provide the FCC registration number and the 
REN (see below) to your telephone 
company. Both numbers are on the bottom 
of your phone. 

±

We have designed your telephone to 
conform to federal regulations, and you can 
connect it to most telephone lines. However, 
each telephone (and each device, such as a 
telephone or answering machine) that you 
connect to the telephone line draws power 
from the telephone line. We refer to this 
power draw as the device's ringer 
equivalence number, or REN on the bottom 
of your phone.

If you use more than one phone or other 
device on the line, add up all of the RENs. If 
the total is more than five (three in rural 
areas), your telephones might not ring. If 
ringer operation is impaired, remove a 
device from the line.

In the unlikely event that your phone causes 
problems on the phone line, the phone 
company can temporarily discontinue your 
service. If this happens, the phone company 
attempts to notify you in advance. If advance 
notice is not practical, the phone company 

notifies you as soon as possible and advises 
you of your right to file a complaint with the 
FCC.

Also, the phone company can make 
changes to its lines, equipment, operations, 
or procedures that could affect the operation 
of this telephone. The telephone company 
notifies you of these changes in advance, so 
you can take the necessary steps to prevent 
interruption of your telephone service.

.+)*60+0)
Your telephone has built-in protection 
circuits to reduce the risk of damage from 
surges in telephone line and power line 
current. These protection circuits meet or 
exceed the FCC requirements. However, 
lightning striking the telephone or power 
lines can damage your telephone.

Lightning damage is not common. 
Nevertheless, if you live in an area that has 
severe electrical storms, we suggest that 
you unplug your phone when storms 
approach to reduce the possibility of 
damage.

Your phone is ETL listed to UL standards 
and meets applicable FCC requirements.

%100'%6+0)"6*'"2*10'
Your telephone connects directly to a 
modular telephone line jack. If your 
telephone wiring does not have a modular 
jack, you can update the wiring yourself 
using jacks and adapters (available at your 
local RadioShack store), or have the 
telephone company update the wiring for 
you. You must use compatible modular 
jacks that are compliant with Part 68 of FCC 
Rules. 

±

Position the supplied mounting bracket so 
the mounting hole’s open end is facing 
downward, then insert the supplied 
mounting bracket’s two tabs into the 
matching slots on the bottom of the base, 
then snap the bracket into place.

To mount the 
phone directly 
on a wall, drill 
two holes 
3

15/16 inches 

(100 mm) 
apart. Then 
thread a 
screw (not 

supplied) into each hole, letting the heads 
extend about 

3/16 inch (5 mm) from the wall. 

Connect the supplied long modular cord to 
the phone’s line jack. Fit the keyhole slots 
over the screw heads and slide the phone 
downward to secure it. Plug the line cord 
into the telephone line jack.

To mount the phone on a wall plate, connect 
the supplied short modular cord as shown. 
Fit the keyhole slots over the wall plate studs 
and slide the phone downward to secure it.

Before you hang up the handset on a wall-
mounted phone, slide up the handset holder 
out of its slot, turn it, and slide it back into its 
slot.

Plug the handset cord into the jacks on the 
handset and the base.

#"+/2146#06"#

If an icon appears at the end of a paragraph, 
go to the box on that page with the 
corresponding icon for pertinent information.

— Warning 

 

# — Important

. — Caution 

 

° — Hint

± — Note

±"016'"±"

FCC Statement
You must not connect your telephone to:

coin-operated systems

party-line systems

most electronic key telephone systems

Connecting the Phone

The USOC number of the jack to be 
installed is RJ11C (or RJ11W for a wall 
plate jack).

You can set the phone on a flat surface or 
mount it directly on a wall or a wall plate 
using the supplied mounting bracket.

$KI"$WVVQP"#ORNKHKGF"35//GOQT["2JQPG

The lightning symbol is intended to 
alert you to the presence of uninsulated 
dangerous voltage within this 
product’s enclosure that might be of 

sufficient magnitude to constitute a risk of electric 
shock. Do not open the product’s case.

The exclamation symbol is 
intended to inform you that 
important operating and 
maintenance instructions are 

included in the literature accompanying 
this product.

!

WARNING: To reduce the risk of fire or shock hazard, do not expose this 
product to rain or moisture.

..CAUTION..

CAUTION: TO REDUCE THE 

RISK OF ELECTRIC SHOCK, DO 

NOT REMOVE COVER OR BACK. 

NO USER-SERVICEABLE PARTS 

INSIDE. REFER SERVICING TO 

QUALIFIED PERSONNEL.

RISK OF ELECTRIC 

SHOCK DO NOT OPEN

!

0.505760s