Pioneer HTZ-434DVD User's Manual

Pioneer Home Theater System User's Manual - HTZ-434DVD.
Download
Page  of 2
4.4, 1823 votes
background image

Setting up your DVD/CD Receiver

1

1

2

3

Check that you have all the accessories, then put 
the batteries in the remote control.

Video cord

Batteries and 
remote control

FM antenna

Microphone 
(for Auto MCACC setup)

AM loop antenna

2 Connect the AM and FM antennas to the rear panel of the DVD/CD receiver.

1

2

3

Push open the tabs, then insert 
one wire fully into each terminal.

Release the tabs to secure the AM 
antenna wires.

Pull off the protective shields 
of both AM antenna wires.

4 Fix the AM loop antenna to the 

attached stand.
To fix the stand to the antenna, bend in the 
direction indicated by the arrow (fig. A) then 
clip the loop onto the stand (fig. B).

Note: If you plan to mount the AM antenna 
to a wall or other surface, secure the stand 
with screws (fig. C) before clipping the loop 
to the stand. Make sure the reception is clear.

5

6

Place the AM antenna on a flat 
surface and point in the direction 
giving the best reception. 
Don’t let it come into contact with metal 
objects and avoid placing near computers, 
television sets or other electrical appliances.

Connect the FM wire antenna to the FM UNBAL 75

 antenna terminal.

For best results, extend the FM antenna fully and fix to a wall or door  
frame. Don’t drape loosely or leave coiled up. 

Note: 

The signal earth (

H) is designed to reduce noise that occurs when an  

antenna is connected. It is not an electrical safety earth.

When connecting this system or changing connections, be sure to switch the power off with the STANDBY/ON button, and disconnect the power cord from the AC outlet.
Do not use these speakers with any other system or amplifier as this may result in damage or fire.

3 Connect each speaker using the color-coded 

speaker cords. Match them to the colored 
speaker terminals on the rear panel of the 
DVD/CD receiver.

1

2

3

Connect each speaker as shown below.

Twist and pull off the protective 
shields on each wire.

Connect the wires to the 
speaker. Match the colored 
wire with the color-coded 
label (above the tabs), then 
insert the colored wire into 
the red (+) tab and the other 
wire with the black (–) tab. 

For the best surround sound, setup your speakers as 
above. The front left and right speakers should be 
about 1.8–2.7 m apart.

Congratulations! You're done setting up.

Printed in

<XRE3103-A>

These speaker terminals can be hazardous when live. When you connect or  
disconnect the speaker cables, to prevent the risk of electric shock, do not  
touch uninsulated parts before disconnecting the power cord.

Connect the DVD/CD receiver to your TV, then connect the 
supplied power cord.

3

Connect the power cord to the AC inlet.

2

Connect one end to a video input on your TV.
Use the supplied video cord. 

4

1

      

Using the remote control

The remote control  can be used within a range of about 7 
meters from the remote sensor on the front panel, and 
within a 30 degree angle. 
Precautions:
•   The remote control may not work if there is an obstacle 
between the remote control and the display unit, or if the 
remote control is not directed towards the remote sensor 
of the display unit at the correct angle.
•   The remote control may not work properly if strong 
light such as direct sunlight or fluorescent light is shining 
onto the unit’s remote sensor.
•   The remote control may not work properly when this 
unit is used near devices emitting infrared rays, or when 
remote controls of other devices which use infrared rays 
are used. Also, the use of this remote control may cause 
other devices to work improperly.
•   When the operating range of the remote becomes too 
short, replace the batteries.

       Remote control battery caution
Incorrect use of batteries may cause leakage or 
rupture.  
Always be sure to follow these guidelines:
•   Always insert batteries into the battery compartment 
correctly matching the positive 

ª and negative · 

polarities, as shown by the display inside the 
compartment.
•   Never mix new and used batteries.
•   Batteries of the same size may have different voltages, 
depending on brand.  Do not mix different brands of 
batteries. 
•   When disposing of used batteries, please comply with 
governmental regulations or environmental public 
instruction's rules that apply in your country or area.
•   In order to prevent battery leakage, remove the 
batteries when not using the remote control for an 
extended period (one month or more).  If leakage occurs, 
carefully wipe away any battery fluid inside the 
compartment, and replace the batteries with new ones.
•   Do not allow books or other objects to rest on top of 
the remote control, since the buttons may be depressed, 
causing faster exhaustion of the batteries. 

       Additional notes on connecting antennas
•   Keep antenna cables away from the main unit and other 
cables.
•   To assure optimum reception, pull the FM antenna so that it is 
fully extended and not coiled or hanging at the rear of the unit.
•   If reception with the supplied antenna is poor, see the Other 
connections
 section in the main operating instructions for details 
on connecting outdoor antennas.

      Additional notes on speaker placement
If your listening room is of adequate size, place the speakers as 
shown in step 3 to achieve the optimum surround sound effect. 
If you are listening in a fairly small room and a typical surround 
speaker setup is not possible, see Home theater sound setup in 
the instruction manual and the Speaker Setup guide for 
information on the Front surround 3-spot setup option.
When using the standard surround speaker setup as shown in 
step 3, please observe the following guidelines:
•   Install the main front left and right speakers at an equal 
distance from the TV.
•   For optimum effect, install the rear speakers slightly above ear 
level.
•   Install the center speaker above or below the TV so that the 
sound of the center channel is localized at the TV screen.
Precautions:
•   When installing the center speaker on top of the TV, be sure 
to secure it with tape or some other suitable means. Otherwise, 
the speaker may fall from the TV due to external shocks such as 
earthquakes, endangering those nearby or damaging the speaker. 
•   Do not connect the supplied speakers with any other 
amplifier. This may result in malfunction or fire.
•   The front, center and surround speakers supplied with this 
system are magnetically shielded. However, depending on the 
installation location, color distortion may occur if the speaker is 
installed extremely close to the screen of a television set. If this 
happens case, turn the power switch of the television set OFF, 
and turn it ON after 15 to 30 minutes. If the problem persists, 
place the speaker system away from the television set. 
•   The subwoofer is not magnetically shielded and so should not 
be placed near a TV or monitor. Since it is not magnetically 
shielded, do not place any magnetic storage media (such as floppy 
disks and tape or video cassettes) close to the subwoofer.
•   Do not fix the front, center speakers and subwoofer to the 
wall or ceiling; they could cause injury if they fell. 

Connect the other end to the video output of the DVD/CD receiver.
This player is equipped with copy protection technology. Do not connect this 
player to your TV via a VCR using AV cables, as the picture from this player will not 
appear properly on your TV. 

ST+

TUNE+

ENTER

TUNE–

MASTER
VOLUME

ST–

STANDBY/ON

CD

FM/AM

OPEN CLOSE

DVD

TUNER

TV

LINE

L1/L2

1

4

4

¡

8

3

7

0

DVD MENU

RETURN

BASS
MODE

TV  CONTROL

CH

VOL

INPUT

OPEN

MUTE

Color-coded wire 
(Connect to speaker)

Color-coded connector
(Connect to rear panel)

FRONT

SURROUND

Connect the other end to the color-
coded speaker terminals on the 
rear of the DVD/CD receiver (as 
shown at left). Make sure to insert 
completely.
The small lug at the wire-end of the 
speaker plug should face up or 
down depending on whether it's 
being plugged into one of the 
upper or lower three speaker 
terminals. Please make sure to 
connect correctly.

Upper three terminals

Lower three terminals

* Illustration shows 
   the Taiwan model

ANTENNA

3

1

2

4

6

fig. A

fig. B

fig. C

FM

UNBAL 75

      AM

LOOP ANTENNA

6

6

6

6

6

6

OUT

IN

FRONT

CENTER

MCACC

MIC

SURROUND

SUB

WOOFER

R

L

R

R

L

L

LINE 1

AUDIO

SPEAKERS

TV

IN

6

6

6

6

6

6

FM

UNBAL 75

        AM

LOOP ANTENNA

OPTICAL IN

OUT

VIDEO

OUT

IN

FRONT

CENTER

MCACC

MIC

SURROUND

SUB

WOOFER

R

L

R

R

L

L

LINE 1

LINE 2

AC IN

AUDIO

ANTENNA

SPEAKERS

IN

TV AUDIO

IN

CONTROL

S-VIDEO

OUT

COMPONENT

VIDEO OUT

PR

PB

Y

VIDEO

VIDEO

OUT

VIDEO

VIDEO IN

To AC outlet

AC IN

Listening position

Subwoofer (Purple)

Front right 

(Red)

Front left

(White)

Surround left 

(Blue)

Surround right 

(Grey)

Center (Green)

* Illustration shows the Taiwan model

* Illustration shows the Taiwan model

Power cord*

Speaker Setup Guide
What's in the box

• Front speakers x 2
• Center speaker x 1
• Surround speakers x 2
• Subwoofer x 1
• Speaker cords:
   Red/White (Front speakers) 
   4 m x 2
   Green (Center speaker) 4 m x 1
   Blue/Grey (Surround speakers)
   10m x 2
   Purple (Subwoofer) 4 m x 1 
• Non-skid pads (small) x 4
• Non-skid pads (large)
      Taiwan model  x 4
      All other models  x 6

• Front speaker stand bases 
    x 2 
• Screws (for bases) x 6
• Brackets x 2
• Screws (for brackets) x 4
• Mounting brackets x 2 *
• Screws 
   (for mounting brackets) x 2 *

2

4 Connect the speaker system.

1

Center speaker

1

Center speaker

5

2

3

ExtPower

FrtMovie / FrtMusic

Attach the large non-skid pads to the base of the subwoofer.
Use the supplied adhesive to attach 6 pads to the base of subwoofer.

Placing the Subwoofer (Taiwan model only)

Choose your subwoofer placement

The subwoofer supplied with this 
system can be placed upright or 
on its side (flat). Choose the 
position that works best for your 
room, then attach the large non-
skid pads as shown at right.

Upright position

Flat position

Attach the non-skid pads to the Subwoofer

: Non-skid pads

(Singapore/Indonesia/Hong Kong/Phillipines/Malaysia models) 

* Illustration shows the Taiwan model

* Illustration shows the Taiwan model

Attach the speaker stand bases to the stems using the screws provided.
Before securing the base to the stand, thread the speaker wire through the holes provided on the 
base as shown below. Then, once you have aligned the stem and base, secure with the small 
screws at the points shown at right.

Connect the speaker system.
Refer to the Setting up your DVD/CD Receiver (the other part of this 
setup guide)

 to connect the speakers properly. Place them as 

shown in the diagram at far left optimal surround sound.

Attach the smaller non-skid pads to the 
base of the center speaker.
Use the supplied adhesive to attach 4 pads to the 
base of center speaker.

This is a standard multichannel surround sound speaker 
setup for optimal 5.1 channel home theatre sound.

Standard surround 5-spot setup

Attach the smaller non-
skid pads to the base of 
the center speaker. 
Use the supplied adhesive to 
attach 4 pads to the base of 
center speaker.

Place the surround speakers on top of the front 
speakers, turn the surround speakers towards 
the closest wall, lining the arrows up for 
optimal Front Surround.
Turn each surround speaker so that the 

 arrow at the base 

is lined up with the 

 FRONT SURROUND arrow on the front 

speaker. 

This is only necessary with the 

FrtMovie or 

FrtMusic modes. With ExtPower (Extra Power), the 
surround speakers should be in the same direction as the 
front speakers (as shown below). See the operating 
instructions for more on the Front Surround modes.

Secure in position with the brackets provided.
Line up the holes in the bracket with the holes in the speakers, then secure 
with two screws at the points shown below. Make sure you've matched the 
right and left brackets with the speakers (as shown).

This setup is ideal when rear surround speaker placement 
isn’t possible or you want to avoid running long speaker 
cables in your listening area.

Front surround 
3-spot setup

When assembling the speakers, lay 
them down flat on their side to avoid 
accidents or injury. Make sure to use 
a stable surface when assembling, 
setting up, and placing the speakers.

Assembling the speaker stands and securing your front speakers

Secure the speaker wire.
When you're finished, thread 
the surround speaker cords 
through the outlet on the 
back of the speaker stand and 
through the base of the 
brackets as shown below.

Refer to the Setting up your DVD/CD Receiver (the other part of this setup guide)

 to 

connect the speakers properly. 

Safety precautions 
when setting 

Front

left

Subwoofer

Front

right

Surround

left

Surround

right

Center

Listening position

Front

left

Subwoofer

Front

right

Surround

left

Surround

right

Center

Listening position

ExtPower

FrtMovie / FrtMusic

Caution

• Please don't use the any attachments with the 
front speakers other than the brackets provided.

Caution

• Please don't use the any attachments with the front speakers 
other than the brackets provided.

* Please refer to Wall-mounting 

the front and surround speaker 
system 
in the operating 
instructions for installation.

XRE3103A.En.ChH.p65

05.2.22, 4:01 PM

1

Related Manuals for Pioneer HTZ-434DVD

0.594508s