Philips Emotive Micro- MZ1200 User's Manual | Page 9
7
English
3139 115 21642
General Information
This product complies with the radio
interference requirements of the
European Community.
The type plate is located at the rear of the
system.
For users in the U.K.: please follow the
instructions on page 2.
Environmental information
All unnecessary packaging has been omitted. We
have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags,
protective foam sheet).
Your system consists of materials which can be
recycled and reused if disassembled by a
specialised company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old
equipment.
Maintenance
To clean a CD, wipe it in a straight
line from the centre toward the
edge using a soft, lint-free cloth. A
cleaning agent may damage the
disc! Write only on the printed
side of a disc and only with a soft
felt-tipped pen.
Clean the system with a soft,
slightly dampened, lint-free
cloth. Do not use any
cleaning agents as they may
have a corrosive effect.
Do not expose the system
batteries or discs to
humidity, rain, sand or
excessive heat (caused by
heating equipment or direct
sunlight).
Safety information
● Place the system on a flat, hard and stable
surface.
● Place the system in a location with adequate
ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 inches)
clearance from the rear and the top of the unit
and 5 cm (2 inches) from each side.
● The lens may cloud over when the system is
suddenly moved from cold to warm
surroundings, making it impossible to play a disc.
Leave the system in the warm environment until
the moisture evaporates.
● The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
● When the system is switched to Standby mode,
it is still consuming some power. To disconnect
the system from the power supply completely,
remove the AC power plug from the wall socket.
● To avoid overheating of the system, a safety
circuit has been built in. Therefore, your system
may switch to Standby mode automatically
under extreme conditions. If this happens, let
the system cool down before reusing it.
Related Manuals for Philips Emotive Micro- MZ1200
-
Dell Speakers USB Soundbar AC511 Owner's Manual
15 pages
-
Harman Kardon Speakers Onyx Studio Owner's Manual
6 pages
-
Samsung Speakers HW-F450 User's Manual
25 pages
-
Samsung Speakers HW-E450 User's Manual
26 pages
-
Sony Speakers SA-WCT100 Service Manual
76 pages
-
VIZIO Speakers VSB200 - V - Sound Bar Speaker User's Manual
29 pages
-
Yamaha Speakers SV15 Owner's Manual
6 pages
-
Yamaha Speakers YST-SW315 Owner's Manual
24 pages
-
Polk Audio Speakers Speaker N1 User's Manual
41 pages
-
Creative Speakers I-Trigue L3800 User's Manual
1 pages
-
Creative Speakers Inspire P5800 User's Manual
1 pages
-
Creative Speakers Inspire T7700 User's Manual
2 pages
-
Sylvania Speakers Sylvania Speaker SP269 User's Manual
15 pages
-
Energy Speaker Systems Speakers e:XL-S8 User's Manual
22 pages
-
Logic 3 Speakers Logic 3 Speaker Logic3 User's Manual
8 pages
-
Yamaha Speakers HS8/HS7/HS5/HS8S Owner's Manual
20 pages
-
Yamaha Speakers DBR15/DBR12/DBR10 Owner's Manual
2 pages
-
Beats By Dr Dre Speakers pill 2.0 Quick Start Guide
10 pages
-
Beats By Dr Dre Speakers pill xl Quick Start Guide
10 pages
-
Harman Kardon Speakers Esquire Mini Quick Start Guide
2 pages
-
Harman Kardon Speakers Omni 20 Quick Start Guide
2 pages
-
Harman Kardon Speakers Soho Wireless Quick Start Guide
2 pages
-
Jawbone Speakers Mini Jambox User Manual
17 pages
-
JBL Speakers XTREME Quick Start Manual
17 pages