Philips AQ 5055 User's Manual

Philips Portable CD Player User's Manual - AQ 5055.
Download
Page  of 2
4.4, 1969 votes
background image

Instructions for use

AQ 5055  Radio Cassette Recorder 

D I G I TAL

COMPACT CASSETTE

TC text/CvB/9551

AQ 5055 - Radio Cassette Recorder

English

English

Controls/Installation

Radio/Playback

CONTROLS

TOP AND FRONT PANEL - FIG. 1
DBB button - to switch the bass boost on and

off for extra bass.

VOLUME control - to adjust the volume level
MODE selector - to select the sound source:

TAPE/(POWER OFF) - to switch to tape mode

RADIO/(MONO/STEREO)/(POWER ON) - to
switch to radio mode

4 p PHONES stereo headphones socket -

connection for headphones 
(impedance 8-32 ohms)

BAND switch - to select AM or FM 
TUNING control - to tune to a radio station
7 6 FM ST - lights up when program is received

in stereo

MIC
RECORD

0 button

PLAY

1 button

REW

6 button

F.FWD

5 button

STOP/EJ

9 3 button

PAUSE

; button

SIDE AND BACK PANEL - FIG 2
Voltage selector (not all versions)
AC MAINS - socket for mains lead
BEAT CUT switch - to eliminate possible

whistle tones during MW/AM recordings

BATTERY compartment

SUPPLY

Battery supply
• Whenever convenient, use AC power supply if

you want to conserve battery life.

• Open the battery compartment (fig. 2) and

insert six batteries as indicated , type R20,
UM1 or D-cells.

• Remove the batteries if they are exhausted or

if they will not be used again for a long time.
The battery supply is switched off when the
set is connected to the power supply. To
change over to battery supply, pull out the plug
from the MAINS socket ^.

Power supply
• Make sure the power voltage as shown on the

type plate (on the back of the set) corresponds
to your local power voltage. If it does not,
consult your dealer or service organisation.

• If the set is equiped with a voltage selector %

(fig. 2) set this selector to the local mains voltage.

• Connect the power supply lead to the MAINS

socket and the wall socket. The mains supply
is switched on.

• To disconnect the set from the power supply

completely, withdraw the mains plug from the
wall socket.
Important note for users in the UK, 
see Troubleshooting

RADIO RECEPTION

• Set the MODE selector 3 to RADIO.
• Adjust the sound with the VOLUME 2 control.
• For extra amplification of the bass, use the

DBB control 1. You may connect stereo
headphones with 3.5 mm plug to the socket p
PHONES 4. The loudspeakers are then
muted.

• Select the wave band using BAND switch 5.
• Tune to a radio station using the TUNING knob 6.
– For FM, pull out the telescopic aerial. To

improve FM reception, incline and turn the
aerial. Reduce its length if the FM signal is too
strong (very close to a transmitter).

– For AM(MW), the set is provided with a built-in

aerial, so there is no need to use the telescopic
aerial. The aerial can be directed by turning the
whole set.

• When FM ST 6 lights up, you are receiving a

FM stereo transmitter.
A disturbing noise, due to a weak FM stereo
signal can be suppressed by setting the
MONO/STEREO switch 3 to MONO. The FM
ST 6 will disappear and you will hear (and
record) the FM program in MONO.

• The set is switched off if the MODE selector

3 is in position TAPE and no buttons are
pressed.

CASSETTE PLAYBACK

• Set the MODE selector 3 to TAPE.
• Press EJ 

9 # and insert a recorded cassette

(fig. 3). For playback, any cassette type can be
inserted.

• Press PLAY 

1 0 and playback will start

– Playback stops when the tape in the deck

reaches its end.

• Adjust the sound with the  VOLUME control

2. You may connect stereo headphones with
3.5 mm plug to socket p PHONES 4. The
loudspeakers then will be muted.

• For extra amplification of the bass, use the

DBB control 1.

• To interrupt playback press PAUSE 

; $.

• Press STOP 

9 # if you want to stop the

playback before the end of the tape. 
When the end of the tape is reached, the PLAY

1 0 buttons are released.

• The set is switched off if the MODE selector

3 is in the TAPE position and no buttons are
pressed.

Winding the tape
• Press F.FWD 

5 to fast forward the tape. 

• Press REW 

6 to fast rewind the tape.

• Press STOP 

9 to stop fast forward or fast

rewind, or before the end of the tape.

IOIO

IOIO

IOIO

IOIO

IOIO

IOIO

IOIO

IOIO

OIOIOOIOIOO

OIOIOOIOIOO

FM • • • • • •  88

92          96

100         104        106

108 • • • MHz

REC • PLAY

AUTOMATIC STOP MECHANISM

ONE TOUCH RECORDING

DBB

dynamic bass boost

AUTOMATIC STOP MECHANISM

IOIOOOO

OIOIIOOIOO

OIO  OOO

OIOIOOIOIOO

IOIOOOO

OIOIIOOIOO

OIO  OOO

OIOIOOIOIOO

AM • • • • • •  540

600

700          900

1700 • • • • • KHz

1100   1300  1500

Related Manuals for Philips AQ 5055

0.599777s