Philips 20PF8946/37 Quick Start Manual
If you intend to install the LCD TV on the wall. ensure you have the following :
– Standard VESA 100 bracket for 15"/17"/20"/23" LCD TV (not supplied) and four spacers found in the accessory bag.
3139 125 32112
LCD TV
LCD TV
Thank you for purchasing this Philips LCD Television set. You are now the proud owner of a LCD TV set which
promises full value to you as a customer. Before you proceed to install the LCD TV, please follow the steps and
diagrams as shown to familiarise yourself with the correct and safe way of assembling the stand to the TV.
2
23"/58cm
20"/51cm
17"/44cm
15"/39cm
3
ASSEMBLING THE STAND
INSTALLING LCD TV ON THE WALL
For the 20"/23" models, open back
plate cover by gently pulling upwards.
For the 15"/17" models, open back
plate cover by sliding the plate cover
downwards and then pull upwards.
Bottom of swivel base
(20"/23" models only)
Check the stand arm
is rigid and properly
installed. Place the
set upright.
VESA
Bracket
does not
fit
If your VESA bracket does not fit into the slot at
the rear of the LCD TV, proceed to make use of
the four spacers provided. Note : If VESA bracket
fits into the slot, you need not use the spacers.
1
2
3
Spacer
x 4
Screw the four spacers to the holes at the rear of
the set. Ensure the spacers are properly tightened
(torque of 1.2N-m or 1 lbf-in).
Tighten
VESA
bracket
to spacers
23"/58cm
20"/51cm
17"/44cm
15"/39cm
For the 20"/23"models,
close back plate cover
by gently pushing
downwards.
For the 15"/17" models,
close back plate cover by
sliding plate upward.
Align arrow
to the center
1
For swivelling of the stand to function properly, adjust the swivel base at
the back of the stand until arrow is aligned in the center. Align the stand
studs into the holes at the bottom of the set. Put in the screws (provided)
into the 2 holes and tightened with a screwdriver.
CAUTION : While putting in the screws, hold onto the stand.
Place the set facing down on a protective
sheet close to the edge of a flat surface.
Ensure you have the following before
you assemble the stand :
– Two screws (supplied with set)
– One Screwdriver (not supplied)
4
NOTE : No swivel
base for 15"/17" models
Do the following when installing the LCD TV on the wall :
2
1
Ñ
Ñ
Ñ
!
Place the VESA bracket on the spacers and
tightened with the VESA bracket screws.
Also See for Philips 20PF8946/37
Related Manuals for Philips 20PF8946/37
-
Hitachi Televisions LE48W806 Owner's Manual
43 pages
-
Panasonic Televisions TC-P65VT60 Owner's Manual
34 pages
-
Philips Televisions 39PFL2608/F7 Owner's Manual
56 pages
-
Philips Televisions 32HFL5860D/27 Owner's Manual
51 pages
-
Insignia Televisions NS-19E310A13 Owner's Manual
63 pages
-
Sanyo Televisions DP46142 Owner's Manual
29 pages
-
Sanyo Televisions DP42D23 Owner's Manual
2 pages
-
Sanyo Televisions DP46812 Owner's Manual
2 pages
-
Sanyo Televisions DP50843 Owner's Manual
2 pages
-
Sanyo Televisions DP39843 Owner's Manual
2 pages
-
Sanyo Televisions DP26640 Owner's Manual
16 pages
-
Sanyo Televisions DP42740 Owner's Manual
48 pages
-
LG Televisions 42LM620T Owner's Manual
52 pages
-
LG Televisions 32LN5400 Owner's Manual
42 pages
-
LG Televisions 42LE4500 Owner's Manual
220 pages
-
LG Televisions 42LN5400 Owner's Manual
40 pages
-
LG Televisions 32LH2000 Owner's Manual
194 pages
-
LG Televisions 32LH3000 Owner's Manual
194 pages
-
LG Televisions 42PG3000 Owner's Manual
118 pages
-
LG Televisions 50PG3000 Owner's Manual
118 pages
-
LG Televisions 50PZ550T Owner's Manual
140 pages
-
Haier Televisions L32F1120 Owner's Manual
26 pages
-
Haier Televisions LE39F2280 Owner's Manual
47 pages
-
Toshiba Televisions REGZA 37HL67 Owner's Manual
66 pages