Pacific hydrostar 1650 PSI Owner's Manual | Page 3

Pacific hydrostar Washers Owner's Manual - 1650 PSI.
Download
Page  of 20
4.8, 1186 votes
background image

Page 3

For technical questions, please call 1-800-444-3353.

SKU 69488 

        

Sa

FE

ty

Op

ER

ati

O

n

m

aint

Enanc

E

SE

tup

impORtant SaFEty inStRuctiOnS

  WaRninG When using this product basic precautions should 

always be followed, including the following:

Safety Warnings
1.  Read all the instructions before using the product.

2.  To reduce the risk of injury, close supervision is 

necessary when a product is used near children.

3.  Know how to stop the product and bleed pressures 

quickly. Be thoroughly familiar with the controls.

4.  Stay alert – watch what you are doing.

5.  Do not operate the product when fatigued or under 

the influence of medication, alcohol or drugs.

6.  Keep operating area clear of all persons.

7.  Do not overreach or stand on unstable support. 

Keep good footing and balance at all times.

8.  Follow the maintenance instructions 

specified in the manual.

9.  This product Is provided with A Ground Fault 

Circuit Interrupter (GFCI) built into the power 

cord plug. If replacement of the plug or cord is 

needed, use only identical replacement parts.

10. WARNING – Risk of injection or injury–  

do not direct discharge stream at persons.

11.  Connect to individual branch circuit only.

12. WARNING – To reduce the risk of electrocution, 

keep all connections dry and off the ground. 

Do not touch plug with wet hands.

13. Do not abuse the cord.  Never use the cord for 

carrying, pulling or unplugging the pressure 

washer.  Keep cord away from heat, oil, sharp 

edges or moving parts.  Damaged or entangled 

cords increase the risk of electric shock.

14. 

GFci pREcautiOnS 

Test GFCI (Ground Fault Circuit Interrupter) 

before each use as follows:

a.  Plug GFCI into power outlet and press 

reset button.  Indicator should turn on.

b.  Press test button.  Indicator should turn off.

c.  Press reset button again for use.  

Do not use if above test fails. 

The GFCI device does not protect against electrical 

shock due to contact with both circuit conductors or a 

fault in any wiring supplying the GFCI device. 

to allow GFci unit to function properly, 

ExtEnSiOn cORDS muSt nOt BE 

uSED with this pressure washer.

Set up precautions
1.  The work area should have adequate 

drainage to reduce the possibility of a fall 

or electric shock due to wet surfaces. 

2.  Wear ANSI-approved safety goggles 

during set up and use.

3.  Only feed cold, clean water through this tool.  

Pressure washer detergent may be used in 

the soap dispenser only. Do not use caustic 

materials, solvents, flammable materials, or 

detergents not designed for pressure washers.  

Use of any such material can cause injury, 

or damage this tool or personal property.

4.  Prior to starting the Pressure Washer in cold weather, 

check all of the parts of the unit to make sure ice 

has not formed.  Do not store the unit anywhere 

that the temperature will fall near 32° F (0° C).

 

0.523857s