Netgear AG711F Quick Start Manual

Netgear Hubs Quick Start Manual - AG711F.
Download
Page  of 1
4.2, 1712 votes
background image

Gigabit Ethernet Modules  

AG711T / AG711F

The modularity of the FS726 and 750 Switches provides you with a highly 
adaptable network. You not only can configure your network for copper and/or 
fiber gigabit uplinks, but you also can opt to expand your network gradually 
and affordably, as needed.

Installing a Gigabit Ethernet module:
1. Unscrew and remove the module cover plate.
2. Insert the module into the slot, pressing firmly to seat the module.
3. Tighten the module screws.
4. Press the reset button if the power has remained on throughout the installation       
    of the gigabit modules.

Trademarks

NETGEAR is a registered trademark of NETGEAR, Inc., in the 

United States and other countries. All other trademarks and 

registered trademarks are the property of their respective owners. 

All rights reserved.

Statement of Conditions

In the interest of improving internal design, operational function, 

and/or reliability, NETGEAR reserves the right to make changes to 

the products described in this document without notice. NETGEAR 

does not assume any liability that may occur due to the use or 

application of the product(s) or circuit layout(s) described herein.

Certificate of the Manufacturer/Importer

It is hereby certified the NETGEAR Model AG711T and AG711F 

Product Description has been suppressed in accordance with the 

conditions set out in the MBPT-AmtsblVfg 243/1991 and Vfg 

46/1992. The operation of some equipment (for example, test 

transmitters) in accordance with the regulations may, however, 

be subject to certain restrictions. Please refer to the notes in the 

operating instructions. Federal Office for Telecommunications 

Approvals has been notified of the placing of this equipment on 

the market and has been granted the right to test the series for 

compliance with the regulations.

EN 55 022 Declaration of Conformance

This is to certify that the NETGEAR Model AG711T and AG711F 

Product Description is shielded against the generation of radio 

interference in accordance with the application of Council Directive 

89/336/EEC, Article 4a. Conformity is declared by the application 

of EN 55 022 Class A (CISPR 22)

FCC Compliance Notice: Radio Frequency Notice

Federal Communications Commission (FCC) Compliance Notice: 

Radio Frequency Notice

This device complies with part 15 of the FCC rules. Operation is 

subject to the following two conditions:

- This device may not cause harmful interference.

- This device mush accept any interference received, including    

  interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with 

limits for a Class A digital device, pursuant to part 15 of the 

FCC Rules. These limits are designed to provide reasonable 

protection against harmful interference in a commercial 

installation. This equipment generates, uses, and can radiate 

radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference 

to radio communications. Operation of this equipment in a 

residential area is likely to cause harmful interference, in which 

case users will be required to take whatever measures may be 

necessary to correct the interference at their own expense.

Warning/Logo

Warning: This is a Class A product. In a domestic environment, 

this product may cause radio interference, in which case the user 

may be required to take appropriate measures.

Specifications

AG711T: IEEE802.3ab 1000BASE-T Gigabit Ethernet

AG711F: IEEE802.3z 1000BASE-SX Gigabit Ethernet

M1-

AG711-0

0.479334s