Meiko K-200 Owner's Manual | Page 8

Meiko Dishwasher Owner's Manual - K-200.
Download
Page  of 32
4.3, 1042 votes
background image

Page 8

SECTION 3 - INSTALLATION

3.4 Tabling Attachment

1. Position the table lip-in at both ends of the

machine, as shown in Figure 3-4. Be sure
to seat the lip-in against the inner face of
the sidewall of the dishwasher.

Check that the surface height of each
table matches the height of the rack
track of the dishwasher, to ensure a
smooth transition. The standard table
surface height is 34” (864mm).

Check that the dishmachine is level.

The height of the dishmachine, and of
most tables, can be adjusted by rotating
the feet at the end of the legs.
CAUTION
After adjusting the height of the
dishmachine, always check that it is level
to ensure proper operation.

3. After the tables have been positioned

correctly, secure them to the dishwasher
using silicone sealant.

3.5 Accessing the Utility Connections

The utility connections for the machine are
shown in Figure 3-5.

2. Position the dishwasher and tables as follows:

Check that the centerline at the
opening of each table is aligned with
the centerline of the rack track of the
dishwasher.

Figure 3-4:

Tabling

attachment

Sidewall of

dishwasher

Table

lip-in

Figure 3-5: Accessing utility connections

Electric heat:

Terminal blocks 1-3

Steam heat:

Terminal block

Remove top

access panel to

route electrical

supply

Unload End

Vent

K-200 Series

electric heat with

blower dryer:

Terminal block 4

Warm water

110-140°F

Cold water

50°F

Rinse

aid

If machine has a

blower dryer, remove

lower front panel to

access utilities

Steam

connections are

at unload end.

Locations vary

by machine

configuration.

Load End

K-400 Series
electric heat:

Terminal block 4

Detergent

Drain

0.646470s