Maytag MGR8670W User's Manual

Maytag Washers User's Manual - MGR8670W.
Download
Page  of 1
4.2, 1461 votes
background image

30" (76.2 cm) Freestanding Gas Range

PRODUCT MODEL NUMBERS

PRODUCT DIMENSIONS

CABINET OPENING DIMENSIONS

MGR8670W
MGR8772W

MGR8875W

Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

Natural gas: This range is design-certified by CSA International
for use with Natural gas or, after proper conversion, for use with LP
gas.

● 

This range is factory set for use with Natural gas. See “Gas
Conversions” section. The model/serial rating plate located
behind the storage drawer on the right-hand side oven door
frame has information on the types of gas that can be used. If the
types of gas listed do not include the type of gas
available, check with the local gas supplier.

LP gas conversion:

Conversion must be done by a qualified service technician.

No attempt shall be made to convert the appliance from the gas
specified on the model/serial rating plate for use with a different
gas without consulting the serving gas supplier. See “Gas
Conversions” section.

● 

A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is
required. A time-delay fuse or circuit breaker is also
recommended. It is recommended that a separate circuit
serving only this range be provided.

Ref. W10258096A

07-30-09

*Range can be raised approximately 1" (2.5 cm) by adjusting 

the leveling legs.

A.

28¹⁄₂" (72.4 cm) to 29" (73.7 cm) 

depth with handle to backguard 
standoffs.
29" (73.7 cm) depth with handle 
(KitchenAid models only)

B. 35

⁵⁄₈" (90.5 cm) cooktop height 

(maximum) with leveling legs 
screwed all the way in*

C. 47

¹⁄₈" (119.7 cm) overall height 

(maximum) with leveling legs 
screwed all the way in*

D. 29

⁷⁄₈" (75.9 cm) width

E. 26

³⁄₄" (67.9 cm) depth to 

background standoffs

F. Model/serial number plate 

(located behind the 
storage drawer on the 
left-hand side of the oven 
frame) 

G. Rating number plate 

(located behind the 
storage drawer on the 
right-hand side of the 
oven frame)

B*

C*

E

D

A

G

F

B

D

C

E

A

F

I

H

J

K

G

G

J

H

H

L

M

N

Cabinet opening dimensions shown are for 25" (64.0 cm) 
countertop depth, 24" (61.0 cm) base cabinet depth and 
36" (91.4 cm) countertop height.

IMPORTANT: If installing a range hood or microwave hood 
combination above the range, follow the range hood or 
microwave hood combination installation instructions for 
dimensional clearances above the cooktop surface.

Range may be installed with zero clearance to combustible 
construction at the rear and on the sides below the cooktop.

NOTE: 24" (61.0 cm) minimum when bottom of wood or metal 
cabinet is covered by not less than 

¹⁄₄" (0.64 cm) flame retardant 

millboard covered with not less than No. 28 MSG sheet steel, 
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 
0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance between the top of the cooking 
platform and the bottom of an uncovered wood or metal cabinet.

A. 18" (45.7 cm) upper cabinet to countertop
B. 13" (33.0 cm) upper cabinet depth

C. 30" (76.2 cm) min. opening width
D. For minimum clearance to the top of the cooktop, see NOTE.

E. 30

¹⁄₈" (76.5 cm) min. opening width

F. 3" (7.6 cm) min. clearance from both sides of the range to the side 

wall or other combustible material

G. 6" (15.2 cm) width of H (area for gas and electric)

H. Recommended area for gas and electric installation

I. 6" (15.2 cm) height of notched area in H

J. 3

⁵⁄₁₆" (8.4 cm) distance from side of range to H

K. 3" (7.6 cm) width of notched area in H

L. 3" (7.6 cm) distance from wall

M. Cabinet door or hinges should not extend into the cutout.

N. 19" (48.3 cm) height of H

0.538733s