Maytag MEDC215EW Installation Guide | Page 8

Maytag Dryer Installation Guide - MEDC215EW.
Download
Page  of 20
4.4, 1620 votes
background image

8

Direct Wire

A

B C

D

E

F

2. Remove terminal block cover

Before you start, disconnect power. Remove hold-down screw  

(D) and terminal block cover (A).

A. Terminal block cover 

B. External ground conductor screw

C. Center terminal block screw

D. Hold-down screw 

E. Neutral ground wire

F. Hole below terminal block cover

Put power supply cord through the strain relief. Be sure that 

the wire insulation on the power supply cord is inside the 

strain relief. The strain relief should have a tight fit with the 

dryer cabinet and be in a horizontal position. Do not further 

tighten strain relief screws at this point.

For 3-wire Power Supply Cord Connection, see page 9.
For 4 wire Power Supply Cord Connection, continue to 

step 3.

Attach power supply cord  

to strain relief

2.

A

B

C

D

    Attach power supply cord  

     strain relief

Remove the screws from a 3/4" (19 mm) UL listed strain relief 

(UL marking on strain relief). Put the tabs of the two clamp 

sections (C) into the hole (B) below the terminal block opening 

so that one tab is pointing up (A) and the other is pointing 

down (D), and hold in place. Tighten strain relief screws just 

enough to hold the two clamp sections (C) together.

1.

Power supply cord strain relief

Power Supply Cord Connection

0.606814s