Maxi-Cosi TOBI DRU0632 User's Manual | Page 8

English

4.2 Fabric cover
Removing the cover
• Open the belt buckle. Loosen the shoulder belts by pulling them forwards as far as possible (24, 25). 

Unhook the elastic loops from the hooks on both sides of the positioning handle.

• Remove the elastic edge of the cover from the edges of the shell and then carefully loosen the cover at the

front (26, 27).

• Remove the belt buckle pad by pulling it carefully over the belt buckle sideways at an angle. Pass the cover

over the belt buckle (from back to front).

• Loosen the cover from the side points on both sides of the shell (28).
• Loosen the back flap of the cover and fold it forwards (29).
• Remove the cover carefully from the sides (30).
• Loosen the cover behind the belt clamps. The cover has been pushed behind the belt clamps here (31,1)
• Now pull the cover carefully over the headrest (31,2).
• Remove the cover.
• Remove the belt pads of the shoulder belts by loosening the Velcro and the poppers on the outside (32). 
• Remove the belt behind the flap with the Velcro (33).
• Slide the hook clasp out of the loop of the belt pad (34).
• Remove the belt pad from the spring (35). 
• Do this with both belt pads. 
• Repeat the above, with the exception of the clasp, for the two hip belt pads. The hip belt pads are attached

to the belt with Velcro.

• Remove the headrest cover by removing the two elastic bands from the bottom flap under the plastic part (36,1). 
• Loosen the headrest cover on one side under a point and remove the cover carefully on this side of the headrest. 
• Carefully loosen the headrest cover at the edge under the handle at the top of the headrest.
• Now remove the headrest cover carefully (36,2). 

Cleaning the cover
• Wash the cover and belt pads by hand (maximum of 30°C). Do not use a drier. Also see the care

instructions on the cover.

Tip: It is wise to buy an extra cover when purchasing the Maxi-Cosi Tobi so that you can continue to use it
even when the cover is being washed and dried.

Reattaching the cover
• Repeat the above steps in the reverse order!
• NOTE! First attach the 4 belt pads and the headrest cover before reattaching the cover.
• Slide the cover well into the cover edges of the shell all over.
• Check that the cover is tight fitting all over and secured properly.

4.3 Belt buckle and belt adjustment system functioning and cleaning
The proper functioning of the belt buckle and belt adjustment system is very important for the safety of the
child. The most common reason that the buckle and/or belt adjustment system does not function properly is
because it is dirty (from dust, grime, food particles, etc.). Make sure that the belt buckle stays clean by
vacuuming out all dirt. If the belt adjustment system is not functioning properly, contact your supplier or
importer immediately (see back of instruction manual for contact details). Do not use the Maxi-Cosi Tobi
under any circumstances!

The following is a list of possible causes of function failure and possible solutions.

26

24

36

36

35

34

33

32

31

31

30

29

28

27

25

GB

12

EXI0203_GBA_Tobi_I_BW:--  02-10-2008  15:21  Pagina 12