Linear BGUS User's Manual | Page 5

MODEL BGUS/BGUS-D • SG/SG-D OPERATOR INSTALLATION GUIDE

-5-

MOUNTING INSTRUCTIONS 

BGUS/BGUS-D•SG/SG-D

INSTALLATION ON CONCRETE CURB

1.  Uncrate the gate. Avoid damaging the cabinet fi nish.

2.  Leave the machine bolted to the bottom pallet until ready to 

install.

3.  Open the cabinet door.

4.  Remove the bolts holding the gate to its pallet and place the 

machine in position on the curb. Refer to your Equipment Layout 
(EL) drawing for proper positioning of your gate.

5.  With a pencil, mark the location of the mounting holes on the 

concrete.

6.  Set the gate aside. Drill all four mounting holes using a 3/4” 

diameter rotary hammer percussion drill bit. Insert lag screw 
anchors for 1/2” lag bolts. Place the gate back in position, and 
anchor it with 1/2” lag bolts and fl at washers. Lubricate the 
bolts before installation. Flat washers have been supplied to go 
between pavement and cabinet. LINEAR highly recommends 
using the corner mounting holes when mounting barrier 
gates.

7.  Proceed with the rest of the installation process.