Life Fitness 4500HR User's Manual

Life Fitness Treadmill User's Manual - 4500HR.
Download
Page  of 1
4.2, 2021 votes
background image

MO51-00K40-A049

Life Fitness Models 4000 and 4500HR Treadmills
How To… Install the Monocolumn Pad Kit

Tools required: Phillips screwdriver, Socket set

Step 1
Turn the power OFF at the ON/OFF switch and then unplug
the unit from the electrical outlet.

Step 2
Using a Phillips screwdriver, remove the two SCREWS
securing the sides of the VENT COVER to the MOTOR
COVER.

Step 3
Grasp the VENT COVER in the center and pull away from the
MOTOR COVER to disengage the two snap down CLIPS
located on the inside, center of the VENT COVER.

Step 4
Using a Phillips screwdriver, remove the SCREW securing the RETAINING PLATE and FIBERBOARD  WEDGE in
place on the MONOCOLUMN. Discard the RETAINING PLATE, FIBERBOARD WEDGE and SCREW.

Step 5
Loosen, but do not remove, the two nuts on the U-BOLT
securing the MONOCOLUMN to the FRAME and the
SCREW located at the base of the MONOCOLUMN.

CAUTION: BE CAREFUL NOT TO STRAIN OR

DAMAGE THE WIRE HARNESS THAT RUNS

THROUGH THE MONOCOLUMN.

Step 6
Remove the four  SCREWS securing the  MOTOR
COVER in place against the treadmill FRAME. Carefully
lift the MOTOR COVER from the machine.

Step 7
Place the supplied 1/8” PAD (large pad) into the center
area of the recess in the MOTOR COVER (as shown).

Step 8
Place the supplied 1/4” PAD (small pad) centered against
the 1/8” PAD previously placed in STEP 7 (as shown).

Step 9
Carefully slide the MOTOR COVER into position and re-
install the four MOTOR COVER SCREWS.

Step 11
Tighten the U-BOLT nuts and the Phillips SCREW
securely.

Step 12
Place the VENT COVER back into position on the MOTOR COVER and secure it using the two VENT COVER
SCREWS.

INSTALLATION COMPLETE

1/4" Pad

Motor Cover

1/8" Pad

Monocolumn

Motor Cover

Vent Cover

Screws

Monocolumn

Fiberboard Wedge

Screw

Screws

Vent Cover

Retaining Plate

Related Manuals for Life Fitness 4500HR

0.547408s