LG Motorcycle PR200 User's Manual | Page 6

5

 REPAIR AND MAINTENANCE 

q

Chain and Rear Tire Replacement

Tools required: 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches.

2  With a 10mm wrench, 

loosen the brake cable anchor 

and disconnect the cable.

3 With two 8mm wrenches, 

loosen brake housing anchor 

and disconnect. Keep the spacer 

and washers together.

5 With two 17mm wrenches, 

loosen the axle. Push the wheel 

forward to loosen the chain 

and remove from rear and front 

sprocket.
Note: Your hands will get 

greasy doing this.

6  Pull the wheel out. Note the 

arrangement of the hardware 

sequence. 

7 Install the new chain or 

wheel by slipping the chain 

around the axle. Slide the axle 

into the slots on the frame. 

Maneuver the chain onto the 

rear sprocket and front sprocket.

10 To hook up the brake hous-

ing anchor, align the cable guide 

adjuster and install the spacer 

and bolt. Do not tighten until 

fi nal step.

11 Install the brake spring 

and thread the cable wire into 

the cable anchor. Thread the 

cable to its original position and 

tighten securely.

12 Tighten the brake housing 

anchor securely. Re-attach 

the chain guard. Test ride and 

check. Readjust as needed.

Loosen screws and remove 

chain guard. 

4 Loosen and remove both axle 

adjuster nuts.

8  Slide rear frame cap on axle 

adjuster bolt. 

9  Start screwing on both nuts 

alternating 1/8 to 1/4 turn at a time 

until chain is properly tensioned.