LG Motorcycle PR200 User's Manual | Page 4

3

 ASSEMBLY AND SET-UP

1 Swing the handlebars 

outward as shown. You may

have to loosen the clamps 

to allow the bar to pivot on 

the fork.

2 Using a 5mm hex key 

wrench, tighten both the left

and right side handlebar clamps 

by turning the screws clock-

wise. When properly tightened, 

the handlebars cannot be 

twisted out of alignment.

Attaching the Handlebars

      WARNING:

Failure to properly tighten both 

sides may cause the handlebars 

to dislodge while riding and 

may cause you to lose control

and fall. When correctly 

tightened, the handlebars will 

not rotate out of alignment 

under normal circumstances.

Charging the Battery

Your electric motorbike may not have a fully charged battery; therefore it is a good idea to charge the 

battery prior to use. 

• Initial charge time: 12 hours 

• Run time: up to 40 minutes

• Recharge time: up to 8 hours, 

• Average battery life: 250 charge/discharge cycles

   depending on the level of depletion

1 Plug the charger port into the 

port on the electric motorbike. 

The charger works with the 

power switch in either the on or 

off position.

2 Plug the charger plug into a 

wall outlet.

      WARNING:

Always disconnect your electric 

motorbike from the charger before 

cleaning with liquid.

Note: If your charger does not 

look like the one illustrated, 

your unit has been supplied 

with an alternative charger. 

The specifi cations and charging 

procedure would not change.

The charger has a small window 

with one LED or two LEDs to 

indicate the charge status. Refer 

to the illustration on the charger 

unit for the actual “charging” and 

“charged” status indications for 

your model charger. 

Chargers have built-in over-charge 

protection to prevent battery from 

being over-charged. 
Be sure to properly align the 

groove on the charger input 

plug with the corresponding 

socket on the case; otherwise, 

no charging action will occur.

Charger 

Plug 

Charger 

Port

1 Remove two rubber protectors 

from fairing mount. Remove two 

button head screws with rubber 

washers from both sides of fairing 

mount.

2 Position the fairing and 

align holes with holes in fairing 

mount. Attach fairing to 

mounting points and secure 

with screws. 

Attaching the Fairing

3 If you have trouble aligning 

holes, put one screw in place 

loosely and maneuver opposite 

side into position. Tighten all 

screws.