KitchenAid KBGS274LSS User's Manual | Page 3

KitchenAid Gas Grill User's Manual - KBGS274LSS.
Download
Page  of 39
4.8, 2187 votes
background image

3

Tools and parts
needed for Built-in
(combustible
construction)
installations

Location
requirements

Parts supplied

• convertible regulator is set for 4" W.C.

natural gas

Parts needed

The built-in grills are manufactured for
use with natural gas.

To convert to L.P./propane gas, Gas
Conversion Kit no. 4396311 must be
used. Follow Instructions included with kit.

• level
• small flat-blade screwdriver
• flat-blade screwdriver
• Phillips screwdriver
• tape measure or ruler
• slip-joint pliers
• pipe wrench
• scissors or cutting pliers to remove

tiedowns

Materials required:

• gas line shutoff valve
• 1/2" male pipe thread nipple for connection

to pressure regulator

• L.P. gas-resistant pipe-joint compound
• AGA or CSA design-certified flexible

stainless steel appliance connector 
[4-5 ft. (1.2-1.5 m)] or rigid gas supply line
as needed

• non-corrosive leak detection solution

Select a location that provides minimum
exposure to wind and traffic paths. The
location should be away from strong draft
areas.

Do not obstruct flow of combustion and
ventilation air.

WARNING

Fire Hazard

Do not use grill near combustible
materials.

Do not store combustible materials
near grill.

Doing so can result in death or fire.

WARNING

Explosion Hazard

Do not store fuel tank in a garage or
indoors.

Do not store grill with fuel tank in a
garage or indoors.

Failure to follow these instructions
can result in death, explosion, or fire.

The California Safe Drinking Water and
Toxic Enforcement Act requires the
Governor of California to publish a list
of substances known to the State of
California to cause cancer, birth defects,
or other reproductive harm, and
requires businesses to warn of potential
exposure to such substances.
WARNING: This product contains a
chemical known to the State of
California to cause cancer, birth defects,
or other reproductive harm.

This appliance can cause low-level
exposure to some of the substances
listed, including benzene, crystalline silica,
carbon monoxide, toluene, and soot.

WARNING

Fire Hazard

Do not install this grill on or near
combustible materials.

Doing so can result in death or fire.

Clearance to combustible construction
for built-in (combustible construction)
grills:
A minimum of 12" (30.5 cm) must be
maintained between the grill hood, sides
and back and any combustible construction.

Rotisserie 
If your model is equipped with a
rotisserie, 6" (15.2 cm) minimum
clearance on each end is needed for the
motor and skewer.

A grounded, 3-prong outlet located to the
left of the grill is required. (See “Electrical
requirements” section.)

Insulated Jacket
Built-in grill for use in a combustible
enclosure, also includes an insulated
jacket.

In the State of Massachusetts, the
following installation instructions apply:

• Installations and repairs must be

performed by a qualified or licensed
contractor, plumber, or gasfitter
qualified or licensed by the State of
Massachusetts.

• If using a ball valve, it shall be a

T-handle type.

• A flexible gas connector, when used,

must not exceed 3 feet.

0.498531s