Kidde 164144 Brochure

Kidde Industrial Key Security Brochure - 164144.
Download
Page  of 2
4.6, 2278 votes
background image

Introduction
Your SupraSafe is the latest in Rapid Entry key 
control. To fully utilize it’s built-in security features, 
we recommend that reasonable care be given to the 
location and method of mounting.

The vault is coated with a tough, baked polyurethane 

abuse; however, it is always best to locate the vault 
in an area which is sheltered from excessive moisture 
and possible mechanical damage. 

Important!  Contact your local 

 

department for 

 mounting location 

and instructions.

Installation for Supra-Max, SupraSafe 
1, SupraSafe 2HS/2HSR, and Supra-
Safe 2HS/TS-Vault
1. Mount the vault so that the moisture drain hole is 

on the bottom.

2. Use a level to plumb the vault square.

3. Four 5/16-inch lag bolts have been provided for 

surface mounting the vault.

Important! When installing the vault, do not 
over-tighten the four mounting bolts as this 
may distort the outside shell of the vault.
4. To secure the vault to a masonry/brick wall, it 

is necessary to use the anchors provided with 
the 5/16 lag bolts mounting kit. Drill a 1/2” hole 
approximately 1-3/4” deep into the masonry/brick 
wall. It is recommended to use a carbide/masonry 
bit to prevent cracking or shattering. Gently pound 
the anchor into the hole with a hammer so that it is 

5. Caulk between the vault and the wall for better 

6. 

once the vault has been installed.

7. We strongly recommend the wiring of the tamper 

or licensed electrician. The circuit shall conform to 
NEC class 2 or 3, or UL class 634 standards. In no 
case shall the wiring supply more than 30 volts at 
50 ma. Consult local codes and ordinances prior to 
installations.

Figure 1. Side View of Mounted Vault

Drain hole

Chain mounting 
bracket

 P/N 10102664P1 • Feb 2013

© 2013 Kidde. All rights reserved.

Rapid Entry Systems
Installation Instructions

0.569948s