Kenwood VR-409 Owner's Manual | Page 16

Kenwood Appliances Owner's Manual - VR-409.
Download
Page  of 42
4.8, 1764 votes
background image

16

Operations

1

Listening to a source component

2
3

Start playback from the selected source.

"PHONO"
"TUNER"
"CD/DVD"
"TAPE" or "MD"
"VIDEO1"
"VIDEO2"
"VIDEO3"
"DVD/6ch"
"AV AUX"

The input sources change as shown below:

Selecting a source using the INPUT SELECTOR knob

Use the INPUT SELECTOR knob, MUSIC key, or MOVIE key
to select the source you want to listen to.

Use the VOLUME CONTROL (VOLUME +/–) to adjust the
volume.

MUSIC

MOVIE

VOLUME+/–

INPUT SELECTOR

VOLUME CONTROL

Selecting a source using the MUSIC key

"CD/DVD"
"TAPE" or "MD"
"TUNER"
"PHONO"

"VIDEO1"
"VIDEO2"
"VIDEO3"
"DVD/6ch"
"AV AUX"

Selecting a source using the MOVIE key

Preparing for playback

Normal playback

Some preparatory steps are needed before starting playback.

Turning on the receiver

Turn on the power to the related components.

Turn on the power to this receiver by pressing POWER or

SYS.POWER 

 (and ON/STANDBY) key(s).

Selecting MD/TAPE

Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “

TAPE”. To change the

source name associated with the MD/TAPE jacks to “

MD,” follow the

steps below:

Use the INPUT SELECTOR knob to select “MD/TAPE”.

Hold down the AUTO key for more than 2 seconds.

• The source indication changes to “

MD”.

• To return to the original indication, repeat the above procedure.

A ON

Sound from the speakers connected to the SPEAKERS A

terminals on the rear panel.

B ON

Sound from the speakers connected to the SPEAKERS B

terminals on the rear panel.

A+B ON : Sound from both the speakers connected to the SPEAK-

ERS A and B terminals on the rear panel.

A+B OFF : No sound from the speakers. Use this setting when listening

with headphones for stereo sound and virtual surround in all
playback modes.

Selecting the input mode

If you have selected a component connected to the 

CD, DVD, VIDEO2,

or 

VIDEO3  jacks, make sure that the input mode setting is correct for the

type of audio signal to be used.

9

AUTO

INPUT MODE

POWER

ON/STANDBY

INPUT SELECTOR

SPEAKERS A/B

LFE

C

S

RS

LS

TI.VOL

CLIP

MUTE

RDS

EON

PTY

TP

TA

NEWS

L

SP

A

R

SW

B

Selecting the speaker system

Press the SPEAKERS A or B key to select the speaker system to
be used.

The indicator for the speakers you
want to use should be lit.

• Activating a surround mode or selecting “DVD 6ch” as the input

source causes speaker system A to be selected automatically.

• When you use the 

PRE OUT jacks, press the only SPEAKERS A key

to the on position.

Related Manuals for Kenwood VR-409

0.483827s