JVC LYT0002-0B9A User's Manual

JVC MP3 Player Accessories User's Manual - LYT0002-0B9A.
Download
Page  of 1
4.6, 2444 votes
background image

Thank you for purchasing the JVC AP-V8U Car
Battery Cord. This Car Battery Cord is for use
exclusively with the JVC camcorder. To avoid
problems and obtain the best results, please read this
instruction booklet carefully before use.

CAR BATTERY CORD

AP-V8U

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

     CAUTION:       TO REDUCE THE RISK OF ELECTRIC SHOCK,

        DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

       REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.     

The lightning flash with arrowhead symbol, within an 
equilateral triangle, is intended to alert the user to the 
presence of uninsulated "dangerous voltage" within the 
product's enclosure that may be of sufficient magnitude 
to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is 
intended to alert the user to the presence of important 
operating and maintenance (servicing) instructions in 
the literature accompanying the appliance.

PRECAUTIONS
● Prevent water from entering the unit.

● Do not disassemble or modify the unit, as

this will cause danger and malfunctioning.

● Avoid using the unit in places subject to

direct sunlight, excessive humidity and
vibrations.

● Be careful not to deplete the car battery

when operating the JVC camcorder.

● DO NOT use this cord with cars operating

on DC 24V 

 and POSITIVE (+)

GROUNDED.

Note:
The cigarette lighter plug of the car battery
cord might not be able to be inserted
properly into the cigarette lighter socket if
the car is such that the socket is located
inside the ashtray compartment or other
enclosed place.

HOW TO USE

HOW TO REPLACE THE FUSE AND CAP

LYT0002-0B9A

WARNING:
TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS UNIT
TO RAIN OR MOISTURE.
This unit should be used with DC 12V 

 only.

(FOR NEGATIVE GROUNDED CARS ONLY)

CAUTION:
To prevent electric shocks and fire hazards, do NOT
use any other power source.

1. Connect the Car Battery Cord to the

camcorder.

2. Keep the car engine idling.
3. Remove the car cigarette lighter and insert the

cigarette lighter plug of the Car Battery Cord.

4. Turn the camcorder's power on.

● When removing either the power plug or the

cigarette lighter plug, be sure to turn the
camcorder's power off first.

To camcorder’s
DC input jack

To the car’s
cigarette
lighter socket

● When replacing the fuse, take it out by

unscrewing the cap at the tip of the cigarette
lighter plug in the direction of the arrow
(counterclockwise).

● Always use a 125V 2.5A fuse.

● Replace with the provided DIN type cap if your

car's cigarette lighter is of the European type.

CAUTION:
FOR CONTINUED PROTECTION AGAINST
FIRE HAZARD, REPLACE ONLY WITH
SAME TYPE AND RATED FUSE.

SPECIFICATIONS
Input

: DC 12 V 

 (Negative grounded cars only)

Output

: DC 6 V 

 , 1.8 A max.

Weight

: Approx. 100 g (0.22 lbs)

Provided accessory : DIN cap (For European type)

ENGLISH

Cigarette lighter
plug

Cap

Fuse (125V 2.5A)

Cigarette lighter plug

POWER
indicator

Nous vous remercions pour l'achat du Cordon pour

batterie automobile AP-V8U de JVC. Ce cordon est

destiné à être utilisé uniquement avec un camescope

de JVC. Pour éviter des incidents et obtenir le

meilleur de ce cordon, veuillez lire avec soin ce

manuel d'instructions avant de l'utiliser.

CORDON POUR BATTERIE AUTOMOBILE

AP-V8U

PRECAUTIONS A OBSERVER
● Eviter que de l'eau ne pénètre dans ce

cordon.

● Ne pas le démonter ou le modifier car cela

pourrait être dangereux et provoquer de
mauvais fonctionnements.

● Eviter de l'utiliser dans des endroits soumis

à une forte humidité, à des vibrations ou
exposés aux rayons directs du soleil.

● Faire attention de ne pas décharger

complètement la batterie de la voiture en
faisant fonctionner le camescope.

● NE PAS UTILISER ce cordon avec des

automobiles à masse positive (+)
fonctionnement sur 24 V CC 

.

Remarque:
La fiche allume-cigare du cordon pour
batterie automobile peut ne pas être
introduite correctement dans la prise de
l'allume-cigare si cette prise est située dans
le compartiment cendrier ou un autre endroit
encastré.

UTILISATION

REMPLACEMENT DU FUSIBLE ET CAPUCHON

LYT0002-0B9A

AVERTISSEMENT:
POUR EVITER LES RISQUES
D'INCENDIE OU D'ELECTROCUTION,
NE PAS EXPOSER L'APPAREIL A
L'HUMIDITE NI A LA PLUIE.
Cet appareil ne doit être utilisé que sur du
courant continu CC 12 V 

. (Seulement pour les

voitures reliées négativement à la masse.)

ATTENTION
Afin d'éviter tout risque d'incendie ou
d'électrocution, ne pas utiliser d'autres sources
d'alimentation électrique.

1. Raccorder le cordon pour batterie automobile

au camescope.

2. Laisser le moteur au point mort.
3. Enlever l'allume-cigare et introduire la fiche

pour l'allume-cigare du cordon pour batterie
automobile.

4. Mettre en marche l'alimentation du

camescope.

● Quand vous retirez la prise d'alimentation ou

la fiche pour allume-cigare, bien couper
d'abord l'alimentation du camescope.

Vers prise d'entrée
CC du camescope

Vers la prise
de l'allume-
cigare

● Lors du remplacement du fusible, le sortir en

dévissant le capuchon situé au bout de la fiche
pour allume-cigare dans le sens indiqué par la
flèche (sens inverse des aiguilles d'une montre.)

● Toujours utiliser un fusible de 2,5 A 125 V.

● Remplacer avec le capuchon type DIN fourni si

l'allume-cigare de votre voiture est de type
européen.

ATTENTION:
POUR UNE PROTECTION PERMANENTE
CONTRE LES RISQUES D'INCENDIE,
REMPLACER LE FUSIBLE PAR UN AUTRE
DE MEME TYPE ET DE MEME VALEUR.

CARACTERISTIQUES TECHNIQUES
Entrée

: CC 12 V 

 (voitures reliées négativement à la masse seulement)

Sortie

: CC 6 V 

 , 1,8 A max.

Poids

: Environ 100 g

Accessoire fourni

: Capuchon DIN (pour type européen)

FRANÇAIS

Fiche pour allume-cigare

Indicateur
POWER

ATTENTION

RISQUE D'ELECTROCUTION

NE  PAS  OUVRIR

ATTENTION: POUR EVITER TOUT RISQUE D'ELECTROCUTION
ATTENTION: NE PAS OUVRIR LE BOITIER
AUCUNE PIECE INTERIEURE N'EST A REGLER PAR L'UTILISATEUR.
SE REFERER A UN AGENT QUALIFIE EN CAS DE PROBLEME.

Le symbole de l'éclair à l'intérieur d'un triangle
équilatéral est destiné à alerter l'utilisateur sur la
présence d'une "tension dangereuse" non isolée dans
le boîtier du produit. Cette tension est suffisante pour
provoquer l'électrocution de personnes.

Le point d'exclamation à l'intérieur d'un triangle
équilatéral est destiné à alerter l'utilisateur sur la
présence d'opérations d'entretien importantes au
sujet desquelles des renseignements se trouvent
dans le manuel d'instructions.

Capuchon

Fusible (2,5 A 125 V)

Fiche pour
allume-cigare

Related Manuals for JVC LYT0002-0B9A

0.570802s