Jonsered 2036 Workshop Manual | Page 9

Jonsered Chainsaws Workshop Manual - 2036.
Download
Page  of 126
4.8, 1787 votes
background image

9

Safety equipment

1

0,8 mm

Dismantle the brake mechanism and
replace worn or damaged parts.

Fit the brake spring and plate clamp over
the spring.

Fit the chain brake on the crankcase.

Screw tight the cover plate over the guide
bar attachment and fit the brake’s bearing
on the starter unit side.

Dissassemble the brake mechanism and
replace worn or damaged parts.

The brake band should have a minimum
thickness of 0.8 mm at the most worn
place.

Assembly
Mod. 2054/2055

Fit the brake in the reverse order to dis-
mantling.

Begin with by fitting the hand guard.

Lubricate all moving parts with thin oil.

Fit the brake spring by means of a Phillips
screwdriver.

WARNING!

Observe care to avoid injury if the
screwdriver slips.

!

Fit the plate clamp over the spring.

Fit the chain brake on the crankcase.

NOTE!

Make sure that the guide pin on the brake
fits into the hole in the crankcase before
the screws are tightened.

Fit the cover plate on the guide bar  attach-
ment.

Screw tight the screw for the brake’s
bearing on the starter unit side.

Do not forget the washer between the
crankcase and brake!

 

0.574642s