JANOME MS-5027 User's Manual | Page 19

JANOME Sewing Machine User's Manual - MS-5027.
Download
Page  of 111
4.9, 2396 votes
background image

12

Flat side

Lado plano

Méplat vers

Needle

Aguja

Aiguille

1

3

2

1

2

1

3

2

1

2

3

1

1
2

1

2

2

2

1

1

3

2

Changing Needle

Needle clamp screw
Needle clamp

Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you, and lowering
the presser foot.  Loosen the needle clamp screw     by
turning it counterclockwise.  Remove the needle from the
needle clamp     .
Insert a new needle into the needle clamp     with the
flat side to the rear.  When inserting the needle into the
needle clamp     , push it up as far as it goes. Tighten
the needle clamp screw      firmly by turning it clockwise.
To see if the needle is good, place the flat side of the
needle onto something flat (needle plate, glass, etc.).
The gap between the needle and the flat surface should
be consistent.  Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.

1

3

2

1

3

2

1

1

To Remove and Attach the Foot Holder

Thumb screw
Foot holder
Presser bar

• To remove

Remove the thumb screw     by turning it counterclockwise
with a screwdriver.

• To attach

Match the hole in the foot holder     with the threaded
hole in the presser bar     .  Fit the thumb screw     into
the hole.  Tighten the screw     by turning it clockwise with
a screwdriver.

1

3

2

1

Changing Presser Foot

Snap-on button (red button)
Groove
Pin

• To remove

Raise the needle to its highest position by turning the
handwheel counterclockwise.  Raise the presser foot, and
press the red button     on the back of the foot holder.

• To attach

Place the selected presser foot, so that the pin     on the
foot lies just under the groove     on the foot holder. Lower
the presser bar to lock the foot into place.

3

2

Related Manuals for JANOME MS-5027

0.500401s