iSimple ISTY651 User's Manual | Page 9

9

8. Warranty 
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your 
satisfaction. This warranty applies only to the original purchaser of this product from 
an authorized iSimple dealer. This warranty covers any supplied or manufactured 
parts of this product that, upon inspection by iSimple authorized personnel, is found 
to have failed in normal use due to defects in material or workmanship. This warranty 
does not apply to installation expenses. Attempting to service or modify this unit, 
operating this unit under conditions other than the recommended voltage  will render this 
WARRANTY VOID.
Unless otherwise prescribed by law, iSimple shall not be liable for any personal 
injury, property damage and or any incidental or consequential damages of any 
kind (including water damage) resulting from malfunctions, defects, misuse, 
improper installation or alteration of this product. All parts of this iSimple product 
are guaranteed for a period of 1 year as follows:

Within the first 12 months from date of purchase, subject to the conditions above, 

iSimple will repair or replace the product at their discretion, if it is defective in 
material or workmanship providing it is returned to an Authorized iSimple Dealer, 
with PROOF OF PURCHASE from an authorized iSimple dealer.
Warning:

This equipment may be reset by unintentional electrostatic discharge during op-
eration. Exposure to direct sunlight or extreme heat may cause damage or mal-
function.
FCC Class B Radio Frequency 
Interference Statement 

This equipment has been tested and found to comply with the limits for a Class 
B digital device, pursuant to Part 15 of FCC rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause harm-
ful interference to radio communications. However, there is no guarantee that in-
terference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television recption, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
        1. Reorientate or relocate the receiving antenna.
        2. Increase the separation between the equipment and receiver.
        3. Connect the equipment into an outlet on a circuit different from
            that of which the receiver is connected. 
        4. Consult the dealer or an experienced radio / television technical for help.

Notice : The changes or modifications not expressly approved by the party respon-

sible for compliance could void the user authority to operate the equipment.