Intermatic C8835 Owner's Manual

Intermatic Misc Electronics Owner's Manual - C8835.
Download
Page  of 1
4.1, 1568 votes
background image

Model: C8835

REPEAT CYCLE TIMER

DIAL CYCLE: 30 MINUTES

ACTUATING TIME - EACH TRIPPER, 15 SECONDS

SINGLE POLE DOUBLE THROW

SWITCH RATING:  20 AMP. 125-480 VOLTS A.C. 1/2 HP-125V  1 HP-250V.

WIRING INSTRUCTIONS

This  Time  Switch  can  be  wired  to  control  two  circuits  as  single  pole 

double throw, or to control one circuit as single pole single throw, either 

normally  closed  (NC)  or  normally  open  (NO).  To  wire  Time  Switch  as 

desired, see wiring diagram  above. Use solid or stranded COPPER 

only 

wire  with  insulation  to  suit  installation.  Replace  insulator  before  turning 

on electricity.
                 

PROGRAMMING INSTRUCTIONS

1.  SET  PROGRAM  TIME:  Place  tripper(s)  into  dial  at  desired  time(s) 

operation(s) is/are required.

 • ON TIME: First tripper turns on the load for 16-20 seconds. Each  

    additional tripper will lengthen the on time by 15 seconds.

 •  OFF  TIME:  First  tripper  omitted  turns  off  the  load  for  10-14 

    seconds.  Each  additional  space  will  lengthen  the  off  time  by  15 

    seconds.
2.  TO  SET  DIAL,  Turn  dial  in  CLOCKWISE  direction  only.  The  “TIME 

POINTER”  indicates  position  at  which  switch  action  takes  place.

 

 

TIME

DIAL

INSULATOR

TIME

POINTER

CLOCK

MOTOR 

NEUTRAL

NORM. CLOSED CIRCUIT

NORM. OPEN CIRCUIT

                              FIG. 1                                                        WIRING DIAGRAM

CLOCK

COM.

N.C.

N.O.

N.C.

LOAD

NO.

LOAD

TO REMOVE MECHANISM FROM CASE, Disconnect electricity and all 

wiring. Depress retainer spring at upper left, or unscrew mounting screws, 

then grasp dial and pull mechanism out.
IN CASE OF POWER FAILURE, reset dial. See step (2) of programming 

instructions.

INTERMATIC INCORPORATED

SPRING GROVE, ILLINOIS 60081-9698 - U.S.A.

154--00495  

                                                                                                          

                                                                                       

CLOCK MOTOR: 125 VOLTS - 60 HZ.

CLOCK MOTOR VOLTAGE AND CYCLE MUST BE AS SPECIFIED. TO ORDER 

REPLACEMENT, INDICATE PART NO. (WG--) ON MOTOR COVER.

LR3730

LINE

Related Manuals for Intermatic C8835

0.484479s