IKEA LUFTIG HOOD Assembly Instruction | Page 7

IKEA Accessories Assembly Instruction - LUFTIG HOOD.
Download
Page  of 28
4.3, 1742 votes
background image

6. Tape template in place, aligning the template centerline and

bottom of template with hood bottom line and with the
centerline marked on the wall.

7. Mark centers of the 6 fastener locations through the template

to the wall. 

IMPORTANT: At least two of the screws must be installed into
wood.

Remove the template.

8. Drill 

⁷⁄₆₄" (2.75 mm) pilot holes at all locations where screws

are being installed into wood. 

9. Determine and make all necessary cuts in the wall for the vent

system. Install the vent system before installing the hood. See
“Venting Requirements” section.

10. Determine the required height for the 

¹⁄₂" conduit and drill a

1

¹⁄₄" (3.2 cm) hole at this location. 

11. Run wire through the 

¹⁄₂" conduit according to the National

Electrical Code or CSA Standards and local codes and
ordinances. There must be enough 

¹⁄₂" conduit and wires from

the fused disconnect (or circuit breaker) box to make the
connection in the hood’s electrical terminal box.

12. Use caulk to seal all openings.

NOTE: Do not turn on power until installation is complete.

13. Attach 2 mounting hooks to the wall at locations marked on

the template.

7

A

B

A

C

B

B

D

Vent Cover Bracket Installation

Installations using telescoping upper and lower vent cover
assembly. 

1. Position vent cover bracket on wall about 

¹⁄₈" (3 mm) away

from the ceiling. 

2. Mark the hole locations.

3. Drill 

³⁄₈" (9.5 mm) holes for wall anchors and insert anchors

flush with the wall.

4. Attach vent cover bracket to wall.

Installation locations with reduced ceiling heights.

The vent hood may be installed using only the lower vent
cover plus a 

¹⁄₄" (6.4 mm) thick wood filler.

1. For the vent cover to slide down and engage the top of 

the hood, the vent cover bracket must be mounted 

¹⁄₄" 

(6.4 mm) below the ceiling.

2. The remaining space above the vent cover can be filled

with a 

¹⁄₄" (6.4 mm) thick piece of plywood cut to the inside

cross section of the chimney cover and finished to match
the ceiling.

3. Cut the self-adhesive rubber tape supplied with the hood

in 4 identical pieces. Attach two pieces of tape to each
side of the ceiling bracket. 

Install Range Hood

1. Remove hood from carton and set on protected surface.

2. Tip range hood back and remove metal filters.

3. Hang hood on 2 mounting hooks through the rectangular

cutouts on back of hood.

WARNING

Excessive Weight Hazard

Use two or more people to move and install range hood.

Failure to do so can result in back or other injury.

A. Centerline
B. Mounting hook location
C. Fastener locations
D. Mounting height reference

A. Mounting hooks
B. Centerline on wall

A

B

A

A. Rubber tape

A. Vent cover bracket
B. Centerline on wall

Related Manuals for IKEA LUFTIG HOOD

0.537273s