Hunter Hunter Ceiling Fan 22360 User's Manual

Hunter Outdoor Ceiling Fan User's Manual - Hunter Ceiling Fan 22360.
Download
Page  of 8
4.7, 2398 votes
background image

1

41556-01 8/08/03

  © 2003 HUNTER FAN CO.

S I N C E                                          1  8  8  6

®

INSTALLATION INSTRUCTIONS FOR
 HUNTER ORIGINAL® CEILING FANS

!WARNINGS!

• To avoid possible electrical shock, before wir-

ing fan, disconnect power by turning off the cir-
cuit breakers both to the outlet box and to its
associated wall switch location. If you cannot

lock the circuit breakers in the “OFF” position,
securely fasten a prominent warning device,
such as a tag, to the service panel.

• All wiring must be in accordance with national

and local electrical codes. If you are unfamiliar
with wiring, you should use a qualified electri-

cian.

• To reduce the risk of personal injury, install the

fan to the building structure according to these

instructions and use only the hardware sup-
plied.

IMPORTANT!

READ AND SAVE THESE

INSTRUCTIONS!

!CAUTIONS!

• NEVER REST THE FAN ON THE SWITCH HOUS-

ING.  As you prepare the fan for installation, rest

the motor in the liner in which it was packed.

• Be sure to put full contents of the oil tube into

the fan according to the instructions.

• If this fan is used as a replacement for an Origi-

nal® Old-Tyme non-reversible fan, it must be in-
stalled per the instructions included with this
fan.  Failure to do so could result in the fan fall-

ing.  DO NOT HANG THIS FAN ON A SINGLE
“J” HOOK.

• To reduce the risk of noise and to ensure proper

fan operation, do not use a solid-state speed

control with this fan.   Use Hunter speed con-
trols for Hunter Original
® ceiling fans only.

• Do not use an abrasive cleaner on the fan.  A

mild detergent will clean and restore most units
to their original beauty.

Installing Your Hunter® Ceiling
Fan
Note To Installers: Please leave this manual with
the home owner.
Tools needed:

• Pliers

• 3/8” Socket Wrench

• Flat blade screwdriver • Phillips screwdriver
• Electric drill

• 11/64” drill bit

• 4” x 1-1/2” standard octagon electrical box

Step 1: Pre-Installation

1. Select the installation site: Normally this is

near the center of the room, often replacing a light
fixture.  Make certain that ample clearance is left
for the rotating fan blades.  For maximum effi-
ciency, no obstructions (walls, posts, etc.) should be
within 24” of the tips of the blades.  See Figure 1.
NOTE: Mounting should also meet the precautions listed
in Step 3.

Read this entire manual thoroughly before begin-
ning installation.

24”

Minimum
Clearance

7’ Minimum
    Clearance To
    Floor

8’Minimum
   to Ceiling

Figure 1

2. Fan mounting height:  Your Hunter fan

comes with the proper hardware to hang the fan
from a standard 8 foot ceiling so that the fan blades
will be 12” from the ceiling and approximately 7
feet from the floor.  See Figure 1.
NOTE: On vaulted ceilings, up to 45° pitch, you must
use the Hunter Vaulted Ceiling Mounting Kit.

Related Manuals for Hunter Hunter Ceiling Fan 22360

0.555963s