Hotpoint JV347HWW Owner's Manual | Page 10

Hotpoint Hoods Owner's Manual - JV347HWW.
Download
Page  of 16
4.5, 1850 votes
background image

10

 REMOVE EXHAUST ADAPTOR 

If exhausting/venting using the 31ø

4

s x 10s rectangular 

GXFW³RSWLRQDOIRU-9-9-9-9-9
DQG-9PRGHOVRQO\
 
5HPRYHWKHH[KDXVWDGDSWRUIURPWKHLQVLGHRIWKHKRRG

Set it aside along with its mounting screws. 

31ø4s[s 

rectangular 
H[KDXVW

adaptor 

and screws

 

REMOVE FILTER 

Remove the shipping tape holding the metal grease 

filter in place. Pull down on the center of the front edge 

of the filter. The filter will then slip out of the retaining 

tabs on the back.

 REVERSE THE BAFFLE FOR 

DUCTED INSTALLATIONS ONLY -9
-9-9-9DQG-9PRGHOV
,IWKHKRRGLVWREHUHFLUFXODWHGVNLSWRWKHQH[WVWHS

Remove the baffle from the top of the hood. Reinstall 

the baffle so the short side marked “VENTED” is visible. 

The long side of the baffle should be inside the hood.

 REMOVE WIRING COVER 

Remove the wiring cover from inside the hood. 

Set the cover and its mounting screws aside. 

Wiring 

cover

 REMOVE WIRING KNOCKOUT 

Remove either the top or the back wiring knockout as 

needed and install an approved strain relief clamp

2

3

4

5

6

Metal grease filter

Installation Instructions

 

“VENTED” is visible

Strain relief 

clamp

Back 

knockout

Top 

knockout

Strain relief 

clamp

 REMOVE DUCT KNOCKOUT 

If recirculating, non-vented ductless (JN327 and RN328, 

and optional for JV247, JV248, JV347, JV348 and JV367 

models only), skip to Step 11 D and proceed. 

  Using a flat-blade screwdriver, remove the appropriate 

duct knockout from the top or back of the hood. 

31ø4s x 10s Rectangular 

vertical discharge. 

Remove top rectangular 

duct knockout only.

7s Round vertical discharge. 

Remove circular duct 

knockout only.

31ø4s x 10s Rectangular horizontal 

discharge. Remove rear 

rectangular duct knockout only.

7

0.515245s