Hotpoint HTDX100GDWW Installation Instructions

Hotpoint Washers Installation Instructions - HTDX100GDWW.
Download
Page  of 12
4.4, 1159 votes
background image

 WARNING RISK OF FIRE

• To reduce the risk of severe injury or death, follow all installation instructions.
‡&ORWKHVGU\HULQVWDOODWLRQPXVWEHSHUIRUPHGE\DTXDOL¿HGLQVWDOOHU

• Install the clothes dryer according to these instructions and in accordance with local 

codes. In the absence of local codes, installation must comply with National Fuel Gas 

Code, ANSIZ223.1/NFPA 54 or the Canadian Natural Gas and Propane Installation 

Code, CSA B149.1.

• California Safe Drinking Water and Toxic Enforcement Act.

  This act requires the governor of California to publish a list of substances known to 

the state to cause cancer, birth defects or other reproductive harm and requires 

businesses to warn customers of potential exposure to such substances. Gas 

appliances can cause minor exposure to four of these substances, namely benzene, 

carbon monoxide, formaldehyde and soot, caused primarily by the incomplete 

combustion of natural gas or LP fuels. Properly adjusted dryers will minimize 

incomplete combustion. Exposure to these substances can be minimized further by 

properly venting the dryer to the outdoors.

• This dryer must be exhausted to the outdoors.

• Use only 4” rigid metal ducting for exhausting the clothes dryer to the outdoors.

• DO NOTLQVWDOODFORWKHVGU\HUZLWKÀH[LEOHSODVWLFGXFWLQJPDWHULDOV,IÀH[LEOHPHWDO

(semi-rigid or foil-type) duct is installed, it must be UL listed and installed in accordance 

with the instructions found in “Connecting The Dryer To House Vent” on page 6 of this 

manual. Flexible venting materials are known to collapse, be easily crushed, and trap 
OLQW7KHVHFRQGLWLRQVZLOOREVWUXFWGU\HUDLUÀRZDQGLQFUHDVHWKHULVNRI¿UH

• Do not install or store this appliance in any location where it could be exposed to 

water and or weather.

• Save these instructions. (Installers: Be sure to leave these instructions with the 

customer).

In the state of Massachusetts:
 ,QVWDOODWLRQ PXVW EH SHUIRUPHG E\ D TXDOL¿HG RU OLFHQVHG FRQWUDFWRU

SOXPEHURUJDV¿WWHUTXDOL¿HGRUOLFHQVHGE\WKHVWDWH

 :KHQXVLQJEDOOW\SHJDVVKXWRȹYDOYHVWKH\VKDOOEH7KDQGOHW\SH

 $ÀH[LEOHJDVFRQQHFWRUZKHQXVHGPXVWQRWH[FHHGIHHW

Installation

Instructions

Gas Dryer

01

BEFORE YOU BEGIN

Read these instructions completely and 
FDUHIXOO\
• ,03257$17
 Save these instructions 

for local inspector’s use.

• ,03257$17 Observe all  governing 

codes and ordinances.

•  1RWHWR,QVWDOOHU Be sure to leave these 

instructions with the customer.

•  1RWH WR &XVWRPHU  Keep these 

instructions with your Owner’s Manual for 
future reference.

• Before the old dryer is removed from 

service or discarded, remove the dryer 
door.

• Inspect the dryer exhaust outlet and 

straighten the outlet walls if they are bent.

• 

Service information and the wiring 
diagram are located in the control console.

•  Do not allow children on or in the appliance. 

Close supervision of children is necessary 
when the appliance is used near children.

•  Install the dryer where the temperature is 

above 50°F for satisfactory operation of 
the dryer control system.

•  Product failure due to improper installation 

is not covered under the Warranty.

LEVEL

8" PIPE WRENCH

10" ADJUSTABLE WRENCHES

 (x2)

SLIP JOINT PLIERS

FLAT BLADE SCREWDRIVER

M ATERIALS YOU WILL NEED

EXHAUST HOOD

FLEXIBLE GAS LINE CONNECTOR

SOAP SOLUTION

FOR LEAK DETECTION

PIPE

COMPOUND

DUCT TAPE

GLOVES

SAFETY GLASSES

4" DIAM METAL ELBOW

4" DUCT CLAMPS

OR

4" SPRING CLAMPS 

 (x2)

 (x2)

4" DIA. FLEXIBLE METAL (SEMI-RIGID)

UL LISTED TRANSITION DUCT

(IF NEEDED)

 KIT WX08X10077 (INCLUDES 2 ELBOWS)

4" DIA. METAL DUCT

(RECOMMENDED)

4" DIA. FLEXIBLE METAL (FOIL TYPE)

UL LISTED TRANSITION DUCT

(IF NEEDED.)

234D2217P001      31-16735   10-13 GE

DESIGN

CERTIFIED

4XHVWLRQV"&DOO*(&$5(6RUYLVLWRXU:HEVLWHDW*($SSOLDQFHVFRP 

,Q&DQDGDFDOORUYLVLWZZZ*($SSOLDQFHVFD

TOOLS YOU WILL 

NEED

0.585091s