Hotpoint HTDP120EDWW Specifications

Hotpoint Washers Specifications - HTDP120EDWW.
Download
Page  of 3
4.5, 1800 votes
background image

Specification Revised 11/14

HTDP120ED – Hotpoint® 6.8 cu. ft. capacity DuraDrum™ electric dryer

Dryer Dimensions (in inches)

Exhaust Options: 

4-way via rear, right, left and bottom.
Circuit Requirements: 

An individual, properly-grounded branch circuit, protected by a 

30-amp circuit breaker or a time-delay fuse, is required.
Electric Dryer Rating:  

240V, 5600W, 60Hz, 24 Amp

208V, 4400W, 60Hz, 22 Amp
Installation Information: For complete information, see instal ation 

instructions packed with product for current dimensional data.

Listed by 

Underwriters 

Laboratories

Special Installation Requirements
Alcove or Closet Installation: 

•  If your dryer is approved for instal ation in an alcove or closet, it wil  be stated on a 

label on the dryer back.

• The dryer MUST be exhausted to the outside.

•  Minimum clearances between dryer cabinet and adjacent wal s or other surfaces are: 

       0" either side 

       3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”. 

•  Closet doors must be louvered or otherwise ventilated and must contain a minimum of 

60 sq. in. of open area equal y distributed. If this closet contains both a washer and a 

dryer, doors must contain a minimum of 120 sq. in. of open area equal y distributed.

• No other fuel-burning appliance shal  be instal ed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors. 

•  The instal ation must conform with the local codes, or in the absence of local codes, 

with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.

Minimum Clearances other than Alcove or Closet Installation:

•  Minimum clearances to combustible surfaces 

       0" both sides 

       3" rear

36

42

27

2

3-1/2

2-1/2

25-1/2*

Side  View

Rear  View

8-1/2

28-1/4

23-1/2

11-1/2

*24-1/2" from the edge of the side panel to the front.
 25-1/2" from front to edge of endcaps.

* 24-1/2” from the edge of the side panel to the front. 

25-1/2” from front to edge of end caps.

0.496107s