Hotpoint GB Ultima S-Line Washing Machine SWMD 9437 User's Manual | Page 2

Hotpoint Washers User's Manual - GB Ultima S-Line Washing Machine SWMD 9437.
Download
Page  of 16
4.8, 1582 votes
background image

2

GB

Installation

ning the adjustable front feet (see figure); the 

angle of inclination, measured according to the 

worktop, must not exceed 2°.

Levelling your appliance correctly will provide 

it with stability and avoid any vibrations, noise 

and shifting during operation. If it is placed on 

a fitted or loose carpet, adjust the feet in such 

a way as to allow enough room for ventilation 

beneath the washing machine.

Electric and water connections

Connecting the water inlet hose

1. Connect the supply 

pipe by screwing it to a 

cold water tap using a 

3/4 gas threaded con-

nection (see figure). 

Before performing the 

connection, allow the 

water to run freely un-

til it is perfectly clear.

2. Connect the other 

end of the water inlet 

hose to the washing 

machine, 

screwing it onto the 

appliance’s cold water 

inlet, situated on the 

top right-hand side on 

the rear of the applian-

ce (see figure).

3. Make sure there are no kinks or bends in the 

hose.

! The water pressure at the tap must be within 

the values indicated in the Technical details 

table (on the page 5).

! If the water inlet hose is not long enough, 

contact a specialist store or an authorised 

serviceman.

! Ensure that the supply taps are allowing wa-

ter through. Old taps may seize in the closed 

position and thus prevent water reaching the 

machine.

! Never use second-hand or old inlet hoses; 

use the products supplied with the machine.

! Keep this instruction manual in a safe place 

for future reference. Should the appliance be 

sold, transferred or moved, make sure the 

instruction manual accompanies the washing 

machine to inform the new owner as to its 

operation and features.

! Read these instructions careful y: they contain 

vital information on instal ation, use and safety.

Unpacking and levelling
Unpacking

! This is a separate 

part of the polystyre-

ne base and should 

be removed with the 

base.

! IMPORTANT check 

when unpacking 

your machine.

1. Unpack the washing machine.

2. Check whether the washing machine has 

been damaged during transport. If this is the 

case, do not install it and contact your retailer.

3. Remove the 4 pro-

tective screws and 

the rubber bush with 

the respective spacer, 

situated on the rear of 

the appliance (see also 

the installation leaflet).

4. Seal the gaps using 

the plastic plugs provi-

ded.

5. Keep all the parts: 

you will need them again if the washing machi-

ne needs to be moved to another location.

! Packaging materials are not children’s toys.

Levelling

Your machine may make a considerable 

amount of noise if the two front feet have not 

been adjusted correctly.

1. Instal  the washing 

machine on a flat sturdy 

floor, without resting it 

up against wal s, cabi-

nets or anything else.

2. If the floor is not per-

fectly level, compensa-

te for any unevenness 

by tightening or loose-

0.502190s