Hotpoint fdl570 User's Manual | Page 2

Hotpoint Range User's Manual - fdl570.
Download
Page  of 20
4.2, 1798 votes
background image

2

EN

Positioning and levelling

1. Remove the appliance from all packaging and

check that it has not been damaged during

transportation.

If it has been damaged, contact the retailer and do not

proceed any further with the installation process.

2. Check the dishwasher by placing it so that its sides

or back panel are in contact with the adjacent

cabinets or even with the wall. This appliance can also

be recessed under a single worktop

* (see the

Assembly instruction sheet).

3. Position the dishwasher on a level and sturdy floor. If

the floor is uneven, the front feet of the appliance may

be adjusted until it reaches a horizontal position (the

angle of inclination must not exceed 2 degrees). If the

appliance is levelled correctly, it will be more stable

and much less likely to move or cause vibrations and

noise while it is operating.

4

*. Adjust the height of the rear foot from the front of

the appliance* on the central lower part of the

dishwasher, turning a hexagonal spanner (red color)

with an opening of 8 mm in a clockwise direction to

increase the height or in an anticlockwise direction to

decrease the height.

Anti-condensation  strip

*

After installing the dishwasher, open the door and

stick  the  adhesive  transparent  strip  under  the

wooden shelf in order to protect it from any

condensation  that  may  form.

 Keep this instruction manual in a safe place for

future reference. If the appliance is sold, given away

or moved, please ensure the manual is kept with the

machine, so that the new owner may benefit from the

advice contained within it.

 Please read this instruction manual carefully: it

contains important information regarding the safe

installation, use and maintenance of the appliance.

 If the appliance must be moved at any time,

keep it in an upright position; if absolutely

necessary, it may be tilted onto its back.

Advice regarding the first wash cycle

After  the  appliance  has  been  installed,  immediately

before running the first wash cycle, completely fill

the salt dispenser with water and add only then

approximately 1 kg of salt (see chapter entitled

Rinse aid and refined salt). The water may overflow:

this is normal and is not a cause for concern. Select

the water hardness value (see chapter entitled Rinse

aid and refined salt).  - After the salt has been

poured into the machine, the LOW SALT indicator

light

* switches off.

 If the salt container is not filled, the water

softener and the heating element may be damaged

as a result.

* Only available in selected models.

Installation

Technical data

 

Dimensions 

width 59.5 cm 
height 82 cm 
depth 57 cm 

Capacity 

12 standard place-settings 

Water supply 
pressure 

0,05 ÷ 1MPa (0.5 ÷ 10 bar) 
4.3 psi – 145 psi 

Power supply 
voltage 

See appliance data plate 

Total absorbed 
power 

See appliance data plate 

Fuse 

See appliance data plate 

 

This dishwasher conforms to 
the following European 
Community Directives: 

 

-73/23/EEC dated 19/02/73 
 (Low Voltage) and subsequent 
modifications 
-89/336/EEC dated 03/05/89 
(Electromagnetic Compatibility)  
and subsequent modifications 
-97/17/EC (Labelling) 
-2002/96/ CE (

Waste 

Electrical and Electronic 
Equipment WEEE) 

 

0.515960s