Honeywell T8001F User's Manual

Honeywell Thermostats User's Manual - T8001F.
Download
Page  of 8
4.7, 2068 votes
background image

® U.S. Registered Trademark
Copyright © 2001 Honeywel  •                • Al  Rights Reserved 

INSTALLATION INSTRUCTIONS

69-1465-3

T8001F, T8024F Flush Mount

Programmable Thermostat

APPLICATION

The T8001F Thermostat provides single-stage, 

programmable temperature control for 24 Vac heating-
cooling systems with manual changeover from heat to 

cool. The T8024F Thermostat provides multistage 
electronic control of single-zone heating and cooling 

systems. Heating cycle rate is selectable at 1, 3, 4, 5, 6, 
9, or 12 cph. Cooling cycle rate is fixed at 3 cph. 

Temperature indication can be set for °F or °C. 

The T8001F, T8024F Thermostat is powered directly 
from the system transformer. Batteries are not required 

because setpoints are held permanently by non-volatile 
memory.

The T8001F, T8024F model includes a thermostat, 

wal plate and owner’s guide. See Table 1.

MERCURY NOTICE

If this control is replacing a control that contains 

mercury in a sealed tube, do not place your old 
control in the trash. Dispose of it properly.

Contact your local waste management authority 

for instructions regarding recycling and the 
proper disposal of the control. 

INSTALLATION

When Installing this Product…

1. Read these instructions carefully. Failure to follow 

them could damage the product or cause a hazard-
ous condition.

2. Check the ratings given in the instructions and on 

the product to make sure the product is suitable for 

your application.

3. Installer must be a trained, experienced service 

technician.

4. After installation is complete, check out product 

operation as provided in these instructions.

CAUTION

Hazardous Voltage.

Can damage heating/cooling system.
Disconnect power at furnace or main breaker/

fuse box.

Location
Install the thermostat about 5 ft (1.5m) above the floor in 
an area with good air circulation at average temperature. 

See Fig. 1. Do not install the thermostat where it can be 
affected by:

— drafts or dead spots behind doors and in corners.
— hot or cold air from ducts.

— radiant heat from the sun or appliances.
— concealed pipes and chimneys.

— unheated (uncooled) areas such as an outside wal  

behind the thermostat.

Installing Wallplate in Wall

IMPORTANT

Level only for appearance. The thermostat func-

tions normal y even when not level.

Mount wal plate and the T8001F or T8024F with the wing 
anchors provided (see Fig. 2) as follows: 

1. Place the wal plate template at the desired location 

on the wal .

2. Trace and cutout the opening.
3. Pul  the thermostat wire through the wallplate 

entrance hole.

4. Fasten the wal plate to the wall using the wing 

anchors.

Table 1. Thermostat Descriptions.

Model

System

Changeover

System Selection

Fan Selection

Powering Method

T8001F

Heat-Cool

Manual

Cool-Off-Heat

Auto-On

Hardwired

T8024F

Heat-Cool

Manual

Cool-Off-Heat

Auto-On

Hardwired

Also See for Honeywell T8001F

0.461693s