Honeywell RTH111 series Owner's Manual
RTH111
69-2061EFS
-01 11/09 1/8
1.1
Controls
1.2
Display screen
1.3
System switch
Use the System switch to place the system in one of the following
modes.
• Cool: System is in Cooling mode.
• Off: System is off.
• Heat: System is in Heating mode.
CAUTION: EQUIPMENT DAMAGE HAZARD
Do not use Cooling mode when the outdoor temperature
is below 50 °F (10 °C).
1.4
Fan switch
Use the Fan switch to select the fan operation.
• Auto: The fan runs only when heating or cooling is actually taking
place (commonly used setting).
• On: The fan runs continuously. Use this setting for improved air
circulation or for more efficient air cleaning.
1.5
Temperature adjustment
Press the S or T button once to display the setpoint temperature.
Press either button more than once to change the setpoint.
The ambient (measured) temperature is normally displayed. To view
the setpoint temperature, press either of the temperature adjustment
buttons once. The setpoint temperature will appear for five seconds.
1.6
Built-in compressor protection
Your thermostat has a feature that helps prevent damage to the
compressor of your air conditioning system. Because damage can
occur if the compressor is restarted too soon after shutdown, this
feature forces the compressor to wait five minutes before restarting.
During the wait time, the message Cool On flashes on the screen.
When the safe wait time has elapsed, the message stops flashing
and the compressor turns on.
Set the System switch to Off before removing the
batteries. Otherwise, the heating/cooling system could
remain activated even when batteries are removed.
Install two fresh AAA batteries when the low-battery icon flashes on
the screen. The icon appears for 60 days before the batteries are
depleted. Replace batteries once a year, or when you will be away for
more than a month.
The settings are stored in non-volatile (permanent) memory and are
thus saved when the thermostat is without batteries.
n Operation
1.
System switch
Fan switch
Temperature
adjustment buttons
1 When Cool On is flashing, this means the compressor protection is engaged (see
section 1.6).
Temperature
System status
• Cool On: Cooling is
activated. 1
• Heat On: Heating is
activated.
Low-battery warning
Setpoint indicator
Appears when the
setpoint temperature
is displayed.
o Battery replacement
2.
p In case of difficulty
3.
Screen is blank.
• Ensure two fresh AAA alkaline batteries are
correctly installed.
Temperature settings
cannot be changed.
• The System switch is off.
• You are setting the temperatures outside
their allowable ranges:
• Heat: 40 °F to 90 °F (4.5 °C to 32 °C).
• Cool: 50 °F to 99 °F (10 °C to 37 °C).
Cool On is flashing. • The compressor protection delay has been
activated. Cooling will not be activated until
the delay ends (maximum of five minutes).
HI appears on the
screen.
• The ambient (measured) temperature is
above 122 °F (50 °C).
LO appears on the
screen.
• The ambient (measured) temperature is
below 32 °F (0 °C).
E1 appears on the
screen.
• The temperature sensor circuit is opened.
Replace the thermostat.
E2 appears on the
screen.
• The temperature sensor circuit is shorted.
Replace the thermostat.
RTH111
User Guide
Non-programmable Thermostat
400-631-001-A (RTH111 User 69-2061EFS).book Page 1 Tuesday, June 5, 2007 2:24 PM
69-2061EFS-01
Related Manuals for Honeywell RTH111 series
-
Honeywell Thermostats RTH2310B Owner's Manual
44 pages
-
Honeywell Thermostats TH3110D1008 Owner's Manual
16 pages
-
Honeywell Thermostats TH4110D1007 Owner's Manual
24 pages
-
Honeywell Thermostats TH6110D1005 Owner's Manual
24 pages
-
Hunter Thermostats 42999B Owner's Manual
2 pages
-
Hunter Thermostats 43054 Owner's Manual
2 pages
-
Hunter Thermostats 44100A Owner's Manual
33 pages
-
Hunter Thermostats 44100B Owner's Manual
2 pages
-
Hunter Thermostats 44155C Owner's Manual
52 pages
-
Trane Thermostats X1379088401 Owner's Manual
32 pages
-
Honeywell Thermostats T8112D Owner's Manual
8 pages
-
NOMA Thermostats THM301M User's Manual
8 pages
-
Trane Thermostats TCONT802AS32DA Instruction Manual
20 pages
-
Hunter Thermostats Thermostat 44360 User's Manual
23 pages
-
Honeywell Thermostats TH6220D1028 Owner's Manual
24 pages
-
Honeywell Thermostats TH5220D1003 Owner's Manual
20 pages
-
Honeywell Thermostats TH8321WF1001 Installation Guide
12 pages
-
Honeywell Thermostats RTHL3550D Quick Installation Guide
64 pages
-
Honeywell Thermostats RTH6580WF User's Guide
140 pages
-
Honeywell Thermostats RTH221B1039 Operating Manual
48 pages
-
Honeywell Thermostats RTH2300B1038 Operating Manual
48 pages
-
Honeywell Thermostats RTH2300B1038 Quick Installation Guide
56 pages
-
Honeywell Thermostats RTH111B1024 Quick Installation Guide
48 pages
-
Honeywell Thermostats FocusPRO 6000 Series User Manual
24 pages