Honeywell H8908C User's Manual

Honeywell Thermostats User's Manual - H8908C.
Download
Page  of 4
4.8, 1671 votes
background image

® U.S. Registered Trademark
Copyright © 1999 Honeywell Inc. •           •All Rights Reserved 

INSTALLATION INSTRUCTIONS

69- 1341

H8908B Humidistat

H8908C Dehumidistat

APPLICATION

The H8908B Humidistat and H8908C Dehumidistat 
(humidity controllers) provide automatic low voltage 
control of humidifiers and dehumidifiers or ventilators, 
respectively, in central heating and air conditioning sys-
tems. They have a spst, snap-acting, dust-proof switch 
and are designed for wall or surface duct mounting.

INSTALLATION

When Installing this Product...

1.

Read these instructions carefully. Failure to follow 
them could damage the product or cause a haz-
ardous condition.

2.

Check the ratings given in the instructions and on 
the product to make sure the product is suitable 
for your application.

3.

Installer must be a trained, experienced service 
technician.

4.

After installation is complete, check out product 
operation as provided in these instructions.

CAUTION

Personal Injury Hazard.
Power supply can cause electrical shock.
Disconnect power supply before beginning 
installation. 

Location and Mounting
The styling of the H8908 is designed to blend with the 
latest T8600 family of Honeywell Chronotherm® IV 
Deluxe Programmable Thermostats. A mounting tem-
plate is included for mounting the H8908 next to the 
T8600. The H8908 can also be mounted at any other 
convenient location in the living area or equipment 
room. See Fig 1.

NOTE:

The H8908 electrical connections are not 
shared with the thermostat.

Fig. 1. H8908B Humidistat.

Wall Mounting

IMPORTANT

Mount the control in an area with average 
room temperature and average relative 
humidity.

The following mounting instructions are for mounting 
the H8908 on the wall next to the T8600. When install-
ing the H8908 at another location, modify the procedure 
to fit the installation.

1.

Hold the mounting template (included) next to the 
T8600. Select the mounting side for the H8908. 
The template is reversible for mounting on either 
the left or right side of the T8600. See Fig. 2.

2.

Mark the holes for the two mounting screws 
(included). Then mark the hole for the low voltage 
wiring on the template that corresponds with the 
side selected in step 1. 

3.

Remove the template and drill the holes.

4.

Run low voltage wiring to the location and pull 
about 6 in. (152 mm) of wire through the hole.

5.

Plug the hole with nonflammable insulation to 
prevent drafts from affecting the control opera-
tion.

Humidity Control

Régulateur d'humidité

-20 

°F

-10 

°F

°F

+10 

°F

+20 

°F

Over 20 

°F

15%

20%

25%

30%

35%

40%

HUMIDITY

SETTING

OUTDOOR

TEMPERATURE

-30 

°C

-25 

°C

-20 

°C

-10 

°C

-5 

°C

Over 0 

°C

M13371

CASE REMOVAL 
SLOT

HOLE FOR WIRING 
THE DUCT MOUNTING 
INSTALLATIONS

0.544775s