Health o meter HDR743DQ1-41 Owner's Manual

Health o meter Healthcare Owner's Manual - HDR743DQ1-41.
Download
Page  of 2
4.4, 2440 votes
background image

NOTE: BEfOrE usiNg ThE scalE, 

rEmOvE ThE plasTic wrap frOm 

arOuNd ThE BaTTEry aNd iNsTall 

ThE BaTTEry usiNg ThE sTEps lisTEd 

uNdEr Battery replacement.  
Scale Use

Place the scale on a flat surface.  A hard 

surface is best for maximum accuracy. 
Step onto the scale and position your feet 

so that your weight is distributed evenly over 

the scale platform.  Stand still while the scale 

calculates your weight.  The LED display will 

flash "

%" several times for a few seconds 

before displaying your weight.  Stand still while 

reading the display. 

Note:  This scale offers both “Instant ON” (Step 

onto scale) or “Tap ON” (tap on lower right corner 

and wait for “

0.0” for weight measurement). During 

the “Instant ON” weighing, if you see “

“, the 

scale has recalibrated. Please step on the scale to 

weight yourself again.

Whether you remain standing on the scale or 

you step off the scale immediately after your 

weight is displayed, your weight will continue 

to display for a few seconds and then turn off 

automatically.

If "

E" is displayed, the scale has exceeded the 

350 LB maximum weight capacity or it needs to be 

calibrated.  To re-calibrate the scale repeat Step 2 

in Scale Use. 

CARe: Periodically wipe scale surface down with a 

DRY cloth to remove dust. 

CAUtIoN: Weight exceeding the capacity 

(350 LB) may damage your scale. This scale is 

designed for personal use only, not commercial/

industrial use. This scale is not waterproof; avoid 

contact with excessive moisture.

1.

2.

3.

NOTa: aNTEs dE usar la BalaNZa, 

rETirE la cuBiErTa plasTica QuE 

ENvuElvE a la pila E iNsTalE la pila 

siguiENdO lOs pasOs mOsTradOs EN 

reemplaZO De la pIla.
Operación de la Balanza

Coloque la balanza en una superficie plana. 

Es preferible una superficie firme para mayor 

precisión.
Párese sobre la balanza y coloque los pies 

de tal manera que su peso quede distribuido 

uniformemente sobre toda la plataforma de 

la balanza. No se mueva mientras la balanza 

calcula su peso. La pantalla LED titilará "

%" 

por algunos segundos antes de mostrar su 

peso. No se mueva durante este proceso.

NotA: Esta balanza ofrece “Instant ON” 

(parándose sobre la balanza) o “Tap ON” 

(pulsando en la esquina derecha de la balanza  

y esperando a que aparezca “

0.0” antes de 

pesarse). Durante el proceso de “Instant ON”, 

si la pantalla muestra “

”, la balanza se ha 

recalibrado. Párese sobre la balanza y vuelva a 

pesarse.

Sin importar si usted permanece sobre la 

balanza o no después de que su peso ha sido 

mostrado, su peso continuará en la pantalla 

por algunos segundos y luego la balanza se 

apagará automáticamente.

Si aparece "

E" en la pantalla, se ha excedido el 

peso máximo de 350 libras de la balanza o ésta 

necesita ser recalibrada (vea el paso 2). 
CUIDADo De LA BALANZA: Periódicamente 

limpie su balanza con un paño SECO. 
PReCAUCIÓN: Un peso mayor a la capacidad 

de la balanza (350 LB) puede dañar su unidad. 

Este producto está diseñado para uso personal 

solamente, no para uso comercial ni industrial. 

Esta balanza no es resistente al agua. Evite el 

contacto con humedad excesiva.

1.

2.

3.

Digital Scale

www.healthometer.com

Battery
This scale includes one 9V battery. When “LO” appears on the 

display, replace the battery.
Battery replacement

Locate the battery cover on the back of the scale.
Push the locking tab and pull the battery cover upwards.
Remove the battery from the two connectors. 
Insert a new battery and snap each terminal to its 

corresponding connector. 
Replace the battery cover. 

a.
b.
c.
d.

e.

pila
Esta balanza incluye una pila de 9 voltios. Cuando aparezca “LO” 

en la pantalla, reemplace la pila.
reemplazo de la pila

Localice la cubierta de pilas en la parte trasera de la balanza.
Presione la lengüeta de seguridad y retire la cubierta.
Libere la pila de sus dos conectores y retírela.
Inserte una pila nueva de 9 voltios y presione firmemente 

cada terminal en su conector correspondiente.
Coloque nuevamente la cubierta de pilas.

a.
b.
c.
d.

e.

E

tap On

Instant On

0.521561s