Harbor Freight Tools 96144 User's Manual | Page 5

Harbor Freight Tools Fans User's Manual - 96144.
Download
Page  of 8
4.7, 1623 votes
background image

Page 5

SKU 96144

for technical questions, please call 1-800-444-3353.

Using a small flat head screwdriver or similar tool, pull out the Fuse (12) from the 

2. 

Fuse Holder (18)-see Figure 1.  

Do not replace with a different size fuse, as this may result in excessive heat build 

3. 

up and explosion, which can damage the CarHeater/Fan and cause injury.

Mounting

The Heater/Fan can be permanently mounted to the vehicle using Mounting Screws 

1. 

(21) or can be mounted using the Adhesive Tape as desired.  Mount the Heater 
Fan so that it is out of direct sunlight.  Do not mount the Heater Fan on upholstered 
seats or flammable surfaces.

When using Mounting Screws, make certain that all drilling paths are clear of elec-

2. 

trical lines, cables, wire and any other obstructions.

Make certain that there is sufficient length in the Power Cord to reach the Cigarette 

3. 

lighter.

Use the Mounting Base (6) as a guide to mark two holes in the desired surface. 

4. 

Drill holes in the desired surface.

Align the holes in the Mounting Base (6) with the drilled holes.   Mount the Mounting 

5. 

Base (6) using Mounting Screws (21).  

When using the Adhesive Tape (21) mount as follows:  

6. 

Make certain that there is sufficient length in the Power Cord to reach the Cigarette 
lighter.  Wipe the Base (6) with alcohol for a grease-free surface. Peel off one face 
of the Adhesive Tape (21).  Place the tape on the face of the Base (6) and press 
down and hold for one minute to adhere.

Prepare the mounting surface on the car following the same procedure as indicated 

7. 

in the above mentioned paragraph.  Peel the tape backing carefully and position 
the Base (6) on the surface and press into place. Leave in place for an hour before 
use. 

0.530539s